SHINDAIWA KWIET POWER DGK25E (02) PDF MANUAL

(1) Check that the equipment is resting on a flat and stable surface, in order to prevent tipping or sliding.

(2) Check the fuel, lubrication oil and coolant/water levels.

(3) Check that both the generator output breakers is in the OFF position.

Turn the starter switch to the Start position. As soon as the engine starts, release the starter switch. In cold weather, turn the starter switch to the Preheat position until the preheat lamp turns on, and then to the Start position.

After the engine starts, ensure all the monitor lamps remain OFF.

Run the engine at idling speed without load for at least 10 minutes.

Set the required voltage using the voltage adjust knob.

Turn the generator output circuit breaker(s) to the ON position to apply power to the load terminals.

In the event the generator output breaker trips OFF, make the necessary correction or repair (or decrease the load) and wait approximately 1 minute for the thermal relay to reset itself or the main breaker will not reset. After the necessary correction have been made, reset the main breakers by first turning it to the OFF position, and then to the ON position.

When any RED warning monitor lamp turns ON, stop operation immediately and correct the fault before resuming operation.

(1) Turn the load breaker(s) to the OFF position.

(2) Turn the generator output breakers to the OFF position and allow the engine to run at idling speed for about 3 minutes for cooling down.

(3) Turn the starter switch to the STOP position.

This generator is equipped with automatic shutdowns. This feature activates automatically when an abnormally low oil pressure or high water temperature is detected.

If an automatic stop device has activated, turn the starter switch to the STOP position. Correct the cause(s) of the automatic shutdown prior to trying to restart the generator.