SHAD SH38X (01) PDF MANUAL

The maximum weight capacity is 10 kg (22 lbs).

The maximum recommended speed is 120 Km/h (75 Mph). Always check and comply with local traffic laws.

Yes, always secure and lock the side cases before riding.

Only use recommended cleaning products.

The cases are not designed to protect fragile objects.

Maintain a minimum distance of 1 meter (40 inches) when using a power washer.

1. Insert the key and turn it to the unlocked position.

2. Lift the carrying handle upwards.

3. Lift the lid to open the case.

1. Lower the lid until it is closed.

2. Push the carrying handle down until it clicks into place.

3. Insert the key and turn it to the locked position.

1. Unlock and open the side case.

2. Locate the two internal latches (one on each side of the case interior) and lift them up.

3. Pull the two halves of the case apart to expand its volume.

4. Push the internal latches back down to secure the expanded position.

5. Close and lock the side case. WARNING: Ensure latches are secured before closing.

1. Unlock and open the side case.

2. Locate the two internal latches (one on each side of the case interior) and lift them up.

3. Push the two halves of the case together to reduce its volume.

4. Push the internal latches back down to secure the collapsed position.

5. Close and lock the side case. WARNING: Ensure latches are secured before closing.

1. Ensure the case is unlocked.

2. Lift the carrying handle.

3. Position the case onto the 3P System fitting kit installed on the motorcycle.

3.1. Hook the lower part of the case onto the lower mounting points.

3.2. Align the upper part of the case with the upper mounting points.

3.3. Push the case down firmly until it clicks and locks onto the mount.

4. Push the carrying handle down.

5. Lock the case using the key. WARNING: Ensure the case is securely attached before riding.

1. Unlock the case using the key.

2. Lift the carrying handle upwards.

2.1 While lifting the handle, locate and pull the release mechanism/tab situated under the handle area.

3. Lift the case upwards and away from the motorcycle to release it from the mounting points (3.1, 3.2).

4. Push the carrying handle back down.

5. You can now lock the case for carrying or storage. WARNING: Ensure the handle is down before attempting to carry the case.

To convert the case for the 4P System, you need the adapter piece (Ref. 204632R).

1. Identify the mounting screw locations on the bottom rear of the case.

2. Remove the existing screws (if any) from these locations.

3. Position the 4P System adapter piece onto the corresponding area on the case.

4. Secure the adapter piece using the appropriate screws.

The case is now ready to be mounted onto a SHAD 4P System fitting kit.

An Expandable Inner Bag (Ref. X0IB38) is available as an accessory.

An Inner Net (Ref. X0B3801) is included with the side case.