SERENELIFE SLGT150M (01) PDF DOCUMENT

The SERENELIFE SLGT150M grow tent includes the following features:

• Reinforced by Heavy Metal Rods, with Durable Zipper

• Double Stitching Protection to Ensure Long-Lasting Use

• Easily Observe the Plants without Stepping into Tent

• Lightweight and Velcro Design

• Removable Water-Resistant Floor Tray

• Easy to Clean or Wash

• Heavy Duty All Steel Poles

• Double Duct Port Enclosures

• Blocks all Light from Escaping

• Adjustable Vent Doors

• High-Reflectivity, Carbon Filter Belts

• Inner Tool Organizer

• Light-Proof SBS Zippers

• Effectively Improve Light Efficiency

The following components are included in the box for the SERENELIFE SLGT150M:

• Tent Body

• Floor Tray (1)

• Filter Straps (2)

• Grow tent pole shelf (1)

• Triangle Connector / Corner Adapter (8)

• Metal Poles (Framework Support):

• (8) A Pole

• (4) B Pole

• (4) C Pole

• (1) D Strengthen Pole

• (1) E Pole Hanging Bar Lower

• (2) F Pole Hanging Bar Deep

• Construction Materials: 600D Canvas with Metal Poles and Corner Adapters

• Maximum Temperature: 80°C

• Hanging Bar Weight Capacity: 88 lbs.

• Metal Push-Lock Corners: Handle Up to 90 lbs.

• Filter Straps Size: 55″ -inches

• Floor Tray Size (L x W x H): 60″ x 60″ x 3.95″ -inches

• Hanging Bar Size: 60″ -inches

• Pole Shelf Size (L x W x H): 4.72″ x 4.72″ x 2.76″ –inches

• Strengthen Pole Size: 60″-inches

• Tent Body Size (L x W x H): 60″ x 60″ x 80″ -inches

Follow these steps to assemble your SERENELIFE SLGT150M grow tent:

STEP 1: Assemble the Frame

First, assemble the metal pole frame using the A, B, and C poles and the corner adapters as shown in the diagram. Note: Firmly install the Pole shelf on one of the height poles. You may attach the pole shelf from the TOP or BOTTOM and then drag it to your desired position. DO NOT attach the Pole shelf in the middle of the pole.

STEP 2: Place the Tent Shell Over the Frame

Unzip all zippers of the tent completely. Gently pull the top of the tent shell down over the frame, making sure all corners are squarely in place. Having a helper can make this process easier.

STEP 3: Secure the Tent Shell and Install Hanging Bars

Pull the bottom of the tent shell to cover the base of the tent frame properly. Once the shell is in place, put all hanging bars (D, E, F poles) on the top of the frame inside the tent.

STEP 4: Insert the Floor Tray

Place the removable floor tray at the bottom inside the tent.