SEARS 139.53776 (01) PDF Document

The SEARS 139.53776 remote control can be used with any 53000SRT series garage door opener receiver. It features a personalized code with up to 10,000 possible combinations that can be easily changed if desired.

The opener activates when the 4-digit code and ENTER button are pressed. The keypad will blink for 15 seconds after the code is transmitted. During that time you can STOP or REVERSE door travel just by pressing the ENTER key.

The Multi-Function Keyless Entry can be used with any ‘SMART’ receiver. The keypad will illuminate for 5 seconds at the first push of ANY key.

If wrong numbers are accidentally pressed, correction can be made immediately. The ENTER key will transmit only the last four digits.

Open the keypad cover and remove the battery compartment screw. Set the cover aside and remove the battery. Then follow these steps:

1. Center the keypad at eye level against the selected location on the garage exterior.

2. Hold the keypad firmly with the cover half open so both top and bottom mounting holes are visible. Use a punch to mark each hole. Drill two 1/8″ pilot holes. Fasten securely with the screws provided.

3. Insert the plug provided into the top hole to cover the fastening screw. Return the battery, being sure to observe polarity. Refasten the compartment cover.

Yes. For a one-piece door on a brick, stone, or aluminum sided garage, use the optional location (such as the door jamb face) to avoid injury as the door swings up and out.

You may want someone to help at this point. The following procedure prevents the opener from learning the code of another remote control that is transmitting:

1. Decide on a 4-digit code using numbers from 0 to 9. You can use a number more than once (for example, 4, 0, 4, 1).

2. Press the selected code digits on the keypad. PRESS AND HOLD the ENTER button. The keypad light will blink. Press the ‘Smart’ button on the opener end panel. The adjacent indicator light will flash and the door will begin to move. The receiver has now learned the selected keypad code.

To change your code at any time, repeat the steps used for setting the code (Steps 1 and 2).

After programming the keypad, test your portable remote control. If the pushbutton(s) no longer activates the door opener, reprogram the remote control.

The 12 Volt battery should produce power for at least one year. As long as there is adequate power, the keypad will illuminate and the receiver will operate when numbers and ENTER keys are pressed. Replace the battery when keypad illumination becomes dim.

Open the keypad cover and remove the battery compartment screw. Set the cover aside and remove the battery. When replacing, note the battery polarity as marked on the compartment.

Children operating or playing with a garage door opener can injure themselves or others. The garage door could close and cause serious injury or death. Install the door control (or any additional push buttons) out of the reach of children and away from all moving parts of the door and door hardware, but where the garage door is visible. Do not allow children to operate the push button(s) or the remote control(s).

A moving garage door could injure someone under it. Activate the opener only when the door is properly adjusted, you can see it clearly, and there are no obstructions to door travel.