Free English CHAMPION 201072 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD CHAMPION 201072 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
How do I assemble the CHAMPION 201072 after unpacking?
First, open the shipping carton. Next, attach the wheel kit. Finally, connect the battery and add engine oil.
How do I connect the battery on the CHAMPION 201072?
Cut the cable tie on each side of the battery connector. Then, push the two halves of the battery connector together tightly.
What are the oil requirements for the CHAMPION 201072?
The recommended oil is 5W-30. Add up to 20.3 fl. oz. (600 ml). DO NOT overfill.
Where should I position the CHAMPION 201072 for operation?
Move the generator to an open, outdoor area. Point the exhaust away. Never run the generator in enclosed areas, such as inside a house or garage. Keep all objects at least 5 feet (1.5 m) from the generator. Heat from the muffler and exhaust gas can ignite combustible materials.
What type of fuel should I avoid using in the CHAMPION 201072?
When adding fuel, DO NOT use E15 or E85.
Can I have electrical devices plugged in while starting the CHAMPION 201072?
No. DO NOT plug in any electrical devices. Never start or stop the generator with electrical devices connected or turned on.
How do I perform a Wireless Start on the CHAMPION 201072?
1. Turn the fuel dial to the “ON” position.
2. Press the “START/STOP” button on the generator panel to enter standby mode.
3. Press and release the “START” button on the remote key fob.
How do I use the Electric Start feature on the CHAMPION 201072?
1. Turn the fuel dial to the “ON” position.
2. Press the “START/STOP” button on the generator panel to enter standby mode.
3. Press the “START/STOP” button on the generator panel a second time to start the engine.
How do I manually start the CHAMPION 201072 using the recoil cord?
1. Turn the fuel dial to the “ON” position.
2. Move the choke lever to the “CHOKE” position.
3. Pull the starter cord.
4. Move the choke lever to the “RUN” position.
When should I plug in electrical loads to the CHAMPION 201072?
Plug in and connect electrical loads only after the generator has been started.
CLICK HERE TO DOWNLOAD CHAMPION 201072 (01) PDF DOCUMENT