SAVO C-3405-S (01) PDF Document

For your own safety and to ensure the proper operation of the SAVO C-3405-S, please adhere to the following installation safety guidelines:

• The electrical cables must be connected by a trained technician.

• The minimum safety distance between the hob and the suction hood is 650 mm. Some models may be fitted at a lower height; please see the paragraph relating to working dimensions and installation. If the instructions for the gas hob specify a greater distance, this must be taken into account.

• Check that the mains power supply corresponds to the one indicated on the data plate affixed inside the hood.

• Cut-out devices must be installed in the fixed system according to wiring system regulations.

• For Class I appliances, check that the domestic power supply is adequately earthed.

• Connect the hood to the flue using a pipe with a minimum diameter of 120 mm. The fumes must travel the shortest distance possible.

• All air venting regulations must be complied with.

• Do not connect the ducting hood to flues that also carry combustion fumes (e.g. boilers, chimneys, etc.).

• If the hood is used with non-electric appliances (e.g. gas appliances), a sufficient level of ventilation must be guaranteed in the room to prevent exhaust backflow. The negative pressure in the room must not exceed 0.04 mbar to avoid fumes being sucked back into the room.

• The air must not be extracted through a flue that is also used for fumes from gas or other fuel-powered combustion devices.

• If the power cable is damaged, it must be replaced by the manufacturer or by a service technician.

• Connect the plug to a socket that complies with current regulations and is in an accessible position.

Please observe these important cautions during installation:

• Regarding the technical and safety measures for exhausting fumes, it is important that the regulations set by local authorities are complied with scrupulously.

• CAUTION: Remove the protective films before installing the hood.

• Only use screws and hardware of a sort suitable for the hood.

• CAUTION: Failure to install the screws or fixing devices as described in these instructions may mean there is a risk of electric shocks.

The SAVO C-3405-S suction hood has been designed exclusively for domestic use to eliminate kitchen odours. Follow these guidelines for proper use:

• Never use the hood for purposes other than those for which it was designed.

• Never leave high flames under the hood when it is in operation.

• Adjust the intensity of the flame so that it is directed onto the bottom of the cooking pan, making sure it does not wrap around the sides.

• Deep-fryers must be kept under constant supervision when in use: the oil may catch fire if it gets too hot.

• Do not flambé food under the hood, as you might cause a fire.

• Do not look directly at the light through optical devices (binoculars, magnifying glasses, etc.).

• Accessible parts may become extremely hot during the use of cooking appliances.

The SAVO C-3405-S may be used by children over the age of 8 and by persons with limited psycho-physical and sensory abilities or with insufficient experience and knowledge, provided they are carefully supervised and instructed on how to use the appliance safely and on the dangers that it involves.

• Supervise children to make sure they do not play with the appliance.

• Cleaning and maintenance to be performed by the user must not be carried out by children, unless they are under supervision.

• The appliance must not be used by persons (including children) with limited psycho-physical or sensory capacities or with insufficient experience and knowledge, unless they are carefully supervised and instructed.

The controls for the SAVO C-3405-S function as follows:

Proper filter maintenance is crucial for the performance and safety of your SAVO C-3405-S.

• Activated Carbon Filter: This filter is neither washable nor regenerable. It must be replaced approximately every 4 months of operation, or more frequently in case of very intense use (W).

• Grease Filters: The grease filters must be cleaned every 2 months of operation, or more frequently in case of very intense use. They can be washed in a dishwasher (Z).

• Clean the hood using a damp cloth and a neutral liquid detergent.

• For external and internal cleaning of the hood, avoid alcoholic or silicone products.

• If the product or one of its parts is made of stainless steel, use specific non-abrasive products for cleaning and follow the lines of the satin finish during cleaning.

To change the lighting, you must contact the Service Department. (“Please contact the service department to purchase it”).

The symbol on the product or on its packaging indicates that the product must not be disposed of with normal domestic waste. The product must be disposed of at a specialist re-cycling centre for electrical and electronic components. By making sure that this product is disposed of properly, you will help prevent possible negative consequences for the environment and for health that might result from its improper disposal.