RINGCONN GEN 2 AIR RCA-02-9 (01) PDF Document

To ensure your safety, please carefully read the following safety instructions before you use the RINGCONN GEN 2 AIR RCA-02-9:

1. Do not disassemble the housing of the product.

2. Do not replace its built-in battery.

3. Do not use corrosive cleaning agents to clean it.

4. Do not charge when it is damp or not completely dry.

5. Do not expose it to direct sunlight for a long time.

6. Do not use it in a sauna or steam bath.

7. Do not place it in an environment with extreme temperature or humidity.

8. Do not use it if it is deformed or internally damaged.

9. Do not put it in a fire as the battery may explode.

10. Please use RingConn’s standard charging product to charge the ring.

11. If the product temperature rises too high or becomes seriously hot during charging, please suspend charging immediately.

12. This product has a built-in lithium battery. Being out of use for a long time could cause capacity loss, expansion, aging, circuit board corrosion, or other safety hazards to the battery or product damage due to the properties of the battery. It is recommended that you charge the battery to about 70% before stopping use.

13. Rechargeable products are not waterproof and are intended for indoor use only. Never use or store any rechargeable products in bathrooms and other humid environments.

14. The red and green light-emitting diodes (LEDs) in the product emit light within the visible color spectrum. This makes it safer for both the wearer and others nearby.

15. The charging time depends on the initial battery level of the ring and the ambient temperature.

16. Please charge the battery at room temperature. The charging temperature ranges from a minimum of 0°C/32°F to a maximum of 41.5°C/106.7°F.

17. The RingConn Ring communicates with the RingConn app using encrypted Bluetooth communications.

The package for the RINGCONN GEN 2 AIR RCA-02-9 contains the following items:

• RingConn Gen 2 Air Smart Ring

• Charging Dock

• Type-C Cable

• Instruction Manual, Quick Guide

No, the RINGCONN GEN 2 AIR RCA-02-9 is not a medical device. The RingConn and its related applications are not intended to diagnose, treat, cure, or prevent any disease or medical condition. Please consult a medical professional before adjusting your exercise, sleep, or diet program.

If you have any pre-existing health conditions that may be affected by the use of this product, please consult your doctor.

This product may pose a risk to users with certain symptoms or medical conditions. If you have any of the following conditions, please stop using this product and consult your doctor for advice:

• Epilepsy or sensitivity to light;

• Poor blood circulation or abrasions;

• Heart disease or other medical conditions;

• If you are taking any photosensitizing medication.

The RINGCONN GEN 2 AIR RCA-02-9 surface materials are safe for skin contact (ISO 10993 standard). However, prolonged use of the product may cause skin irritation. If you have any redness, swelling, itching, or other allergic symptoms, please consult your doctor and seek medical advice promptly.

The size of your finger changes at different times of the day, and sometimes it may be difficult to remove the ring. If you have difficulty removing the ring, please try the following methods:

• Wet your finger with mild soapy water or cold water and slowly turn it to remove the ring;

• Raise your hand above your chest until your blood pressure drops and then try to remove it;

• In case of emergency and if you feel uncomfortable and are unable to remove the ring on your own, please seek medical advice immediately.

• Please keep the ring at the right level of looseness so that it is not too tight to prevent poor blood flow.

• Do not use or view the product while driving or in situations that require concentration.

• Remove the ring to avoid wear and tear when performing strength training, holding a shovel or other heavy tool, or holding objects made of metal, ceramic, or stone.

• Please do not put the ring into an ultrasonic cleaner to avoid damage to some of the components.

• While using this product, do not apply too many skincare products to your hands to avoid corrosion of its surface.

• Clean the ring regularly with water and mild soap, and wipe the ring with a soft cloth, paying special attention to the parts in contact with the skin.

• Remove your ring from time to time to give your skin a chance to relax, and you may use this time to recharge your ring.

• The ring may be scratched and may scratch the skin that is in close contact with the ring. Jewelry made of softer materials such as gold and silver, and electronic products with soft coatings should be used with care and protection to avoid scratching by the ring.

The RINGCONN GEN 2 AIR RCA-02-9 is waterproof in daily life (IP68 Protection Grade). You can wear it in swimming pools and other shallow water activities. Please avoid using it in hot springs, saunas (steam baths), diving, and any other environment with extreme temperature or humidity.

If the RINGCONN GEN 2 AIR RCA-02-9 causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, you are encouraged to try to correct the interference by one or more of the following measures:

– Reorient or relocate the receiving antenna.

– Increase the separation between the equipment and receiver.

– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

– Consult the dealer or an experienced radio/TV technician for help.