PIONEER GEX-1550DTV (01) PDF Document

1. Do not install the display where it may (i) obstruct the driver’s vision, (ii) impair the performance of any of the vehicle’s operating systems or safety features, including air bags, hazard lamp buttons or (iii) impair the driver’s ability to safely operate the vehicle.

2. Do not operate this display if doing so in any way will divert your attention from the safe operation of your vehicle. Always observe safe driving rules and follow all existing traffic regulations. If you experience difficulty in operating the system or reading the display, park your vehicle in a safe location and make necessary adjustments.

3. Please remember to wear your seat belt at all times while operating your vehicle. If you are ever in an accident, your injuries can be considerably more severe if your seat belt is not properly buckled.

4. Never use headphones while driving.

5. To promote safety, certain functions are disabled unless the parking brake is on, and the vehicle is not in motion.

6. Never set the volume of your display so high that you cannot hear outside traffic and emergency vehicles.

Keep the vehicle engine running when using the PIONEER GEX-1550DTV to avoid draining the battery power.

WARNING: Do not use the PIONEER GEX-1550DTV with vehicles that do not feature an ACC position.

WARNING: Do not attempt to install or service your display by yourself. Installation or servicing of the display by persons without training and experience in electronic equipment and automotive accessories may be dangerous and could expose you to the risk of electric shock or other hazards.

The PIONEER GEX-1550DTV is a TV tuner for the Pioneer DVD RDS AV Receiver.

CAUTION: Do not allow the PIONEER GEX-1550DTV to come into contact with liquids. Electrical shock could result. Also, damage to the unit, smoke, and overheating could result from contact with liquids.

Keep this manual handy for future reference.

Always keep the volume low enough to hear outside sounds.

Avoid exposure to moisture.

If the battery is disconnected or discharged, any preset memory will be erased.

The microprocessor must be reset in the following situations:

• Before using this unit for the first time after installation

• If the unit fails to operate properly

• When strange or incorrect messages appear on the display

Press RESET with a pen tip or other pointed instrument.

The PIONEER GEX-1550DTV can not be installed in a vehicle that does not have an ACC (accessory) position on the ignition switch.

Use the PIONEER GEX-1550DTV only under the following conditions:

• Vehicles with a 12-volt battery and negative grounding.

Use of the PIONEER GEX-1550DTV in conditions other than the above could result in fire or malfunction.

To prevent a short-circuit, overheating or malfunction, be sure to follow the directions below:

• Disconnect the negative terminal of the battery before installation.

• Secure the wiring with cable clamps or adhesive tape. Wrap adhesive tape around wiring that comes into contact with metal parts to protect the wiring.

• Place all cables away from moving parts, such as the shift lever and seat rails.

• Place all cables away from hot places, such as near the heater outlet.

• Do not connect the yellow cable to the battery by passing it through the hole to the engine compartment.

• Cover any disconnected cable connectors with insulating tape.

• Do not shorten any cables.

• Never cut the insulation of the power cable of this unit in order to share the power with other devices. The current capacity of the cable is limited.

• Use a fuse of the rating prescribed.

• Check all connections and systems before final installation.

• Do not use unauthorized parts as this may cause malfunctions.

• Consult your dealer if installation requires drilling of holes or other modifications to the vehicle.

• Install the unit where it will not get in the driver’s way and will not injure passengers if there is a sudden stop.

• When mounting this unit, make sure none of the leads are trapped between this unit and the surrounding metalwork or fittings.

• Do not mount this unit near heater outlets where it would be affected by heat, or near the doors where rainwater might splash onto it.

• Before drilling any mounting holes, always check behind where you want to drill the holes. Do not drill into the gas line, brake line, electrical wiring or other important parts.

• If this unit is installed in the passenger compartment, anchor it securely so it does not break free while the vehicle is moving, causing injury or an accident.

• If this unit is installed under the front seat, make sure it does not obstruct seat movement. Route all leads and cords carefully around the sliding mechanism so they do are not caught or pinched in the mechanism and cause a short-circuit.

Connect the other end of the RGB cable (supplied) to the RGB IN input on the back of your Pioneer AV receiver. Secure the RGB cable with the 11 mm (.4 in) screw (supplied).

Connect the Black (GND) wire of the power code (supplied) to the vehicle (metal) body.

Connect the Yellow (B+) wire of the power code (supplied) to a terminal always supplied with power regardless of the ignition switch position, using a Fuse (3 A, 250 V).

The General Specifications for the PIONEER GEX-1550DTV are as follows:

The TV tuner specifications for the PIONEER GEX-1550DTV are as follows: