PHILIPS RWSS9500 (01) PDF MANUAL

PHILIPS RWSS9500 (01) PDF SUMMARY:

How do I place the wireless receiver?

Place the wireless receiver near the AC outlet and in between the rear speakers. Align the wireless receiver with the home theater, with the Philips logo facing the home theater. For best reception, make sure that the line-of-site between the wireless receiver and the home theater is not blocked by furniture, walls, and other objects.

How do I connect the wireless transmitter?

Connect the wireless transmitter to the WIRELESS REAR AUDIO connector on the back of the home theater.

For RWSS5510, how do I connect the rear speakers to the wireless receiver?

Connect the speaker adapters, rear left, and rear right speakers to the matching connectors at the bottom of the wireless receiver.

For RWSS9500, how do I connect the rear speakers to the wireless receiver?

Connect the rear left and rear right speakers to the matching connectors at the back of the wireless receiver.

How do I connect the power cord?

Ensure that the power supply voltage corresponds to the voltage printed on the back or the underside of the product. Connect the power cords for the home theater, wireless receiver, and other devices after you have made all of the other connections. The wireless indicator lights and the wireless receiver are then ready to use.

What should I do if there is no sound from the rear speakers and the indicator on the wireless receiver blinks continuously for more than one minute?

For home theater with Blu-ray:

1. Disconnect the power cord and the speaker cables from the wireless receiver for one minute, and place the wireless receiver near the home theater.
2. Switch off the home theater and then switch it on again.
3. Switch the home theater to either AUX source or MP3 link source.
4. Connect the power cord for the wireless receiver. The indicator on the wireless receiver blinks.
5. Press and hold the Navigation button (right) until ‘PAIRING’ blinks on the home theater display panel. ‘PAIRED’ is displayed.
6. Connect the speaker cables to the wireless receiver. The wireless receiver is ready to use again.
7. If ‘FAILED’ is displayed, repeat steps 1 to 6.

For other home theater:

1. Disconnect the power cord from the wireless receiver for a few seconds and connect it back again.
2. Press .
3. Press INFO. A screen is displayed.
4. Press 1, then press SURR within five seconds. ‘PAIRING SUCCESS’ is displayed.
5. If ‘PAIRING FAIL’ is displayed, repeat steps 1 to 4.