PHILIPS RWSS5510 (01) PDF Document

To mitigate the risk of electric shock or fire with your PHILIPS RWSS5510, please follow these safety guidelines:

• Never expose the product and accessories to rain or water. Never place liquid containers, such as vases, near the product. If liquids are spilt on or into the product, disconnect it from the power outlet immediately.

• Never place the product and accessories near naked flames or other heat sources, including direct sunlight.

• Never insert objects into the ventilation slots or other openings on the product.

• Where the mains plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable.

• Disconnect the product from the power outlet before lightning storms.

• When you disconnect the power cord, always pull the plug, never the cable.

Before you connect the PHILIPS RWSS5510 to the power outlet, ensure that the power voltage matches the value printed on the back or bottom of the product. Never connect the product to the power outlet if the voltage is different.

Risk of injury or damage to the product!

• Never place the product or any objects on power cords or on other electrical equipment.

• If the product is transported in temperatures below 5°C, unpack the product and wait until its temperature matches room temperature before connecting it to the power outlet.

Risk of overheating!

• Never install this product in a confined space. Always leave a space of at least four inches around the product for ventilation. Ensure curtains or other objects never cover the ventilation slots on the product.

Place the wireless receiver near the AC outlet and in between the rear speakers. Align the wireless receiver with the home theater, with the Philips logo facing the home theater. For best reception, make sure that the line-of-site between the wireless receiver and the home theater is not blocked by furniture, walls, and other objects.

Connect the wireless transmitter to the WIRELESS REAR AUDIO connector on the back of the home theater.

Connect the speaker adapters, rear left, and rear right speakers to the matching connectors at the bottom of the wireless receiver. The rear speakers shown in the manual’s picture may vary from your product.

Connect the power cords for the home theater, wireless receiver, and other devices after you have made all of the other connections. Once connected, the wireless indicator lights and the wireless receiver will be ready to use.

Warning: Risk of product damage! Ensure that the power supply voltage corresponds to the voltage printed on the back or the underside of the product.

Follow these steps:

1. Disconnect the power cord and the speaker cables from the wireless receiver for one minute, and place the wireless receiver near the home theater.

2. Switch off the home theater and then switch it on again.

3. Switch the home theater to either AUX source or MP3 link source.

4. Connect the power cord for the wireless receiver. The indicator on the wireless receiver will blink.

5. Press and hold the Navigation button (right) until ‘PAIRING’ blinks on the home theater display panel. ‘PAIRED’ will be displayed.

6. Connect the speaker cables to the wireless receiver. The wireless receiver is ready to use again.

7. If ‘FAILED’ is displayed, repeat steps 1 to 6.

Follow these steps:

1. Disconnect the power cord from the wireless receiver for a few seconds and connect it back again.

2. Press the power button.

3. Press INFO. A screen will be displayed.

4. Press 1, then press SURR within five seconds. ‘PAIRING SUCCESS’ will be displayed.

5. If ‘PAIRING FAIL’ is displayed, repeat steps 1 to 4.

• Power supply rating: 110-240V; ~50-60 Hz

• Total output power: 250 W (RMS)

• Power consumption: 50 W

• Standby power consumption: ≤ 0.45 W

• Frequency response: 150 Hz ~ 20 kHz

• S/N Ratio: 65 dB (A-Weighted)

• Distortion: 1%

• Dimensions (WxHxD): 126 x 131 x 126 (mm)

• Weight: 1.1 kg

Note: Specification and design are subject to change without notice.

• Frequency response: 5.8 GHz

• Dimensions (WxHxD): 55 x 53 x 33 (mm)

• Weight: 0.05 kg