Free English PHILIPS LCU7720 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD PHILIPS LCU7720 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
What is the primary safety warning for the PHILIPS LCU7720?
Ensure that the AC power mains are turned OFF before handling the mains wiring, or connecting any power mains cabling to the PHILIPS LCU7720 device.
What are the installation steps for the PHILIPS LCU7720?
1. Disconnect the power before beginning installation.
2. Mount the transformer securely using four screws. See mounting recommendations for best practices.
3. Connect the device to earth.
4. Connect the input and output wiring according to the diagrams. Use twisted wire with an isolation rating greater than 1kV for transmitter connections. Ensure you do not exchange the input and output connections.
5. When connecting to a transmitter like the LFC7710, remove the jump wire from the PHILIPS LCU7720 and then power on the system.
What are the mounting recommendations for the PHILIPS LCU7720?
It is recommended to install the PHILIPS LCU7720 horizontally at the bottom of a cabinet if possible. The cabinet should have an IP rating of IP65 or above.
If mounting vertically, please observe the following warning: Make sure the transformer is securely mounted considering its weight (3.1 kg). It is also advised to mount it as low as possible. If the transformer is not securely mounted and were to drop, it might cause high currents and there is a risk of electrical shocks.
What are the wiring specifications for the PHILIPS LCU7720?
Transmitter Connections (Input from Transmitter):
Input: 490V square wave
Wire Size: 0.8 to 2.0 mm² (AWG 18 to 14)
Torque: 4 Kgf.cm
Wire Strip Length: 7.5 ±0.5 mm (0.3 ±0.02 in)
Conductor Type: Use copper conductors only, rated 75° C minimum.
L1 in/out, L2 in/out Connections:
Wire Size: 10 to 25 mm² (AWG 8 to 4)
Torque: 20.7 Kgf.cm
Maximum Current: 2x 25.6 A max
Wire Strip Length: 13 ±0.5 mm (0.5 ±0.02 in)
Conductor Type: Use copper conductors only, rated 105° C minimum.
What are the physical dimensions of the PHILIPS LCU7720?
Maximum Height: 129 mm (5.1 in)
Maximum Width: 139 mm (5.5 in)
Maximum Depth: 108 mm (4.3 in)
Mounting Hole Spacing (Horizontal): 120 mm (4.7 in)
Mounting Hole Spacing (Vertical): 26 mm (1.0 in)
Chassis Mounting Hole Diameter: 5.5 mm (0.22 in) (4x)
Cover Screw Hole Diameter: 7 mm (0.3 in) (4x)
What are the operating specifications for the PHILIPS LCU7720?
Operating Temperature: -20° C to 60° C
IP Rating: IP00
Weight: 3.1 kg
Relative Humidity (RH): 20 – 90%
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
CLICK HERE TO DOWNLOAD PHILIPS LCU7720 (01) PDF DOCUMENT