PHAISER ENYX BHS-760 (02) PDF Document

To charge your PHAISER ENYX BHS-760, please follow these steps:

Step 1. Connect the charging cable to the charging port on the headphones.

Step 2. Plug the other end of the cable into a USB wall charger or a computer that is powered on.

The LED indicator will turn red while charging and will turn blue once the headphones are fully charged. A full charge takes approximately 1-2 hours.

To pair your PHAISER ENYX BHS-760, follow these steps:

Step 1. With the headset powered off, press and hold the Multi-Function Button (MFB) until the LED indicator flashes red and blue alternately. This indicates the headset is in pairing mode.

Step 2. Activate the Bluetooth function on your phone or other device and search for available Bluetooth devices.

Step 3. Select “BHS-760” from the list of found devices.

Step 4. If prompted for a password or PIN, enter “0000”.

Step 5. Once pairing is successful, the LED indicator will flash blue.

Your PHAISER ENYX BHS-760 can connect with two Bluetooth devices simultaneously. To pair with a second device, follow these steps:

Step 1. After successfully pairing with the first device (Device A), turn off the headset.

Step 2. Turn off the Bluetooth function on Device A.

Step 3. Follow the standard pairing procedure to connect the headset to the second device (Device B).

Step 4. Once paired with Device B, turn on the Bluetooth function on Device A.

Step 5. Select “BHS-760” in the Bluetooth list on Device A to connect.

The headset is now connected to both devices.

To ensure a comfortable and secure fit for your PHAISER ENYX BHS-760, follow these instructions:

Step 1. Choose the proper size ear tips. The headphones come with multiple sizes; select the one that fits you best.

Step 2. Wear the ear hooks over your ears.

Step 3. Adjust each earphone until it fits flush in your ear and the ear tip seals in the ear canal.

Step 4. Tighten the cable cinch to fix the earphones in place for the most secure fit.

If your PHAISER ENYX BHS-760 does not turn on, the battery may be empty. Please charge the headset for at least 1 hour using the provided USB cable and then try turning it on again.

If you are having trouble pairing your PHAISER ENYX BHS-760, please try the following steps:

1. Make sure the headset is in pairing mode (the LED indicator should be flashing red and blue alternately).

2. Ensure that your phone or device’s Bluetooth function is turned on.

3. Confirm that you have selected “BHS-760” from the Bluetooth device list on your phone.

4. Try moving your phone closer to the headset and away from any interference or obstructions.

5. If the issue persists, try clearing the pairing list by resetting the headset.

If you can only hear sound from one earbud, please try turning off both the PHAISER ENYX BHS-760 headset and your connected device. Then, turn them both back on and repair them.

To address low or distorted sound issues, please check the following:

1. Adjust the volume on both your connected device and the headset itself.

2. Ensure the distance between the headset and your device is not too far and that there are no walls or other obstructions between them.

If the microphone seems to not be working well, please check to make sure that the microphone is not covered or blocked in any way.

To reset your PHAISER ENYX BHS-760 and clear its pairing list, follow these steps:

1. Connect the headset to the charging cable as if you were charging it.

2. While it is charging, press and hold the Multi-Function Button (MFB) for 3-5 seconds.

3. The LED indicator will flash red three times, which confirms that the pairing list has been cleared.