PETRAINER PET805A (01) PDF DOCUMENT

1. Connect the charger connector to the charging jack.

2. Plug the charger into a standard outlet.

3. The 3 led lights will be flashing one by one.

4. Charge the Collar Receiver at least 4 hours for the first charge.

5. After fully charged, the first red LED light will keep lighting.

6. After charging is completed, replace the rubber cover.

1. Open the storage cover by pushing according to the direction.

2. Insert the bottle to the right position.

3. Install the cover back.

1. Move the head of the black cover of the storage bottle to the position indicated in the manual and hold for 3 seconds.

2. The first LED light will keep flashing until the Magnetic switch is turned on/off.

3. When it’s turned on, it’s in the working modes.

To fit different dogs, the PETRAINER PET805A spray collar is designed to be able to adjust the sensitivity of the bark. There are 3 levels of sensitivity.

1. There are three indicator lights near the power switch.

2. When the power is connected, only one indicator light is on. At that time the bark sensitivity is the highest (a weaker bark can also cause the spray to burst).

3. To change the sensitivity, approach the black cover of the storage bottle to the indicator light once (do not keep it there for over 3 seconds, or the spray collar will treat it as a shutdown order). The number of lit indicator lights will vary. If one indicator light is on, the bark sensitivity is the highest. When two lights are on, the bark sensitivity is in the middle. When three indicator lights are on, the bark sensitivity is at the lowest level (only a stronger bark can cause the spray to burst).

If you find the spray collar can’t spray after you use it for a while, please follow these instructions to check:

1. Please take out the bottle from the unit and check whether it’s empty and needs to be refilled. If needed, please release the air from the bottle first and then refill the bottle.

2. If you don’t need to refill, then take out the bottle from the unit and wait for at least half an hour and then reinstall the bottle back to the right position.

The spray should work properly.

• Don’t immerse it into the water. You’d better not use it in the rainy day.

• Please clean the product with a dry cloth.

• Don’t let your dog catch or bite the product.

• When the electricity of the batteries in the receiver is not enough, please charge them in time.

• We strongly suggest that you should charge the batteries with the charger we offer.

• Don’t disassemble the product.

If the dog feels uncomfortable when wearing the collar, you can take it off for a while, and use it again when the dog calms down.

The temperature the product can be used in is between 2 and 45 centigrade. Using the product beyond or below this temperature range will damage it.

The product can only be used on healthy dogs. If the dog has had physical or mental problems, please turn to professional veterinarians first. Before using the product, make sure your dog is healthy.

The product isn’t a toy, don’t let the children use it, and don’t use it casually.