PELCO SD53SM-P (01) PDF MANUAL


Post questions, comments, reviews or errors in the comment box below.

Your File is Ready … Download PDF

CLICK HERE TO DOWNLOAD PELCO SD53SM-P (01) PDF MANUAL


PDF Content Summary: C2459M (2/03) SD53SM-P Metal Ceiling Panel for ® Spectra IIITM Series Surface Mount Dome IMPORTANT SAFEGUARDS AND WARNINGS Prior to installation and use of this product, the following WARNINGS should be observed. 1. Installation and servicing should be done only by qualified personnel and conform to all local codes. 2. Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X, 6, or 6P enclosure, it is designed for indoor use only and it must not be installed where exposed to rain and moisture. 3. The installation method and materials should be capable of supporting four times the weight of the unit and equipment. 4. Only use replacement parts recommended by Pelco. DESCRIPTION The SD53SM-P metal ceiling panel is designed for use with BB53-SMW and BB53T-SMW Spectra IIITM Series surface mount back boxes. The metal ceiling panel replaces the 2' x 2' ceiling tile in suspended ceiling installations. The following parts are supplied: 1 2' x 2' metal panel 4 T-rail clips 3 8-32 Phillips pan head screws and washers Pelco World Headquarters • 3500 Pelco Way • Clovis, California 93612 USA • pelco.com USA & Canada • Tel: 800/289-9100 • Fax: 800/289-9150 International • Tel: 1-559/292-1981 • Fax: 1-559/348-1120 INSTALLATION To install the SD53SM-P do the following: 1. Remove the ceiling tile from the ceiling. 2. Refer to Figure 1. Use the three 8-32 screws and washers to secure the back box to the metal panel. Figure 1. Back Box Installation 3. Install the panel in the ceiling. 4. Attach a T-rail clip on each side of the metal panel as shown in Figure 2. Figure 2. T-Rail Clip Installation REVISION HISTORY Manual # Date Comments C2459M 2/03 Original version. ® Pelco and the Pelco logo are registered trademarks of Pelco. © Copyright 2003, Pelco. TM Spectra III is a trademark of Pelco. All rights reserved. T-RAIL CLIP METAL PANEL 5. Install the dome drive and lower dome. Refer to the installation manual supplied with the back box for instructions.


FREE ENGLISH PDF

OPERATING INSTRUCTIONS

USER GUIDE - USER MANUAL

OWNER GUIDE - OWNER MANUAL

REFERENCE GUIDE - REFERENCE MANUAL

INSTRUCTION GUIDE - INSTRUCTION MANUAL

Leave a Reply