Free English OMRON FZ-SPC (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD OMRON FZ-SPC (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
What are the safety warnings regarding the OMRON FZ-SPC Small Digital Camera?
• This product is not designed or rated for ensuring safety of persons. Do not use it for such purposes.
• It is likely to lose one’s sight unusually. Please do not look at the sun light directly with the lens unit.
What are the safety cautions regarding handling the OMRON FZ-SPC Small Digital Camera?
Please do not put it on the place where direct sunshine tries the lens with the lens removed from the camera. A fire might occur unusually.
What locations should be avoided when installing the OMRON FZ-SPC Small Digital Camera?
Do not install the OMRON FZ-SPC Small Digital Camera in locations subjected to the following conditions:
• Ambient temperature outside the rating
• Rapid temperature fluctuations (causing condensation)
• Relative humidity outside the range of 35 to 85%
• Presence of corrosive or flammable gases
• Presence of dust, salt, or metallic particles
• Direct vibration or shock
• Reflection of intense light (such as other laser beams or electric arc-welding machines)
• Direct sunlight or near heaters
What precautions must be observed when handling and installing the OMRON FZ-SPC Small Digital Camera?
• In the installation, tighten the screw, the lens, and the photograph ring surely.
• The Camera amplifier case is connected to the OV line in the internal circuits. Observe the following precautions to prevent noise interference:
• Do not ground the Camera.
• Please use the plinth and the mounting bracket when you set it up.
What are the precautions regarding using accessories with the OMRON FZ-SPC Small Digital Camera?
• Do not use unspecified camera cable and a strobe controller other than those that specified in this manual with the FZ controller. Connection with unspecified camera cable and/or strobe controller may malfunction at the worst case.
• If you do not use the enhancing connector on the back of the camera amplifier, do not remove the cap that is attached to the connector.
• Do not attempt to dismantle, repair, or modify the main body.
• If you suspect an error or malfunction, stop using the Controller immediately, turn OFF the power supply, and consult your OMRON representative.
• Dispose of FZ-SC5M/S5M components as industrial waste.
What precautions should be taken when connecting cables to the OMRON FZ-SPC Small Digital Camera?
• Be sure to turn off the power before connecting or disconnecting the cables. The camera might break when the power supply detaches it while turned on.
What must be checked regarding the optical axis of the OMRON FZ-SPC Small Digital Camera?
• The center of the optical axis varies with the camera used. Therefore, when installing the camera, always check the center of the image displayed on the monitor.
How should maintenance be performed on the OMRON FZ-SPC Small Digital Camera?
• If large dust particles adhere to the CCD, use a blowerbrush (used to clean camera lenses) to blow them off. Do not blow the dust particles with your mouth.
• Do not use thinners, benzene, acetone, or kerosene to clean Camera.
What accessories are included with the OMRON FZ-SPC Small Digital Camera?
Main unit, instruction sheet(this manual), mounting bracket (only FZ-SFC/SF), four screws(M2×4 only FZ-SFC/SF)
How is the lens and photograph ring used with the OMRON FZ-SPC Small Digital Camera?
(1) Mount of lens as shown in the figure below, and screw in to the inner of the camera mount. Put the photograph ring between the camera head and the lens after referring to an optical diagram when you want to use it in the narrowness view and the short distance.
(2) Loosen the lens and the photographing ring to the position in which the focus of the image is suitable, and fix firmly with the lens fixation ring.
(3) Rotate a knob after adjusting the brightness of the image by the disphragm adjustment knob, detain temporarily, and fix firmly with the fixed screw of the other side.
What are the usable ranges for the lens draw out dimension for the OMRON FZ-SPC Small Digital Camera?
The draw out dimension of lens for the Diaphragm adjustment knob is 0.7mm to 2.7mm.
The lens draw out dimension must be used within the range of 0mm to 2.0mm. The lens and the photographing ring might come off according to the environment of use when used by the dimension outside the range.
How can the base mount position of the OMRON FZ-SPC camera amplifier be changed?
The camera base attached to the bottom of the camera amplifier can also be attached to the another side of the camera amplifier. Remove the four screws (M2×7) from the base and re-attach the base to the another side of the camera amplifier. (Recommended screw tightening torque: 0.32N·m)
When the plinth is attached in the top side and the side, mount it by three mounting screws.
How can the base mount position of the OMRON FZ-SPC camera head (FZ-SPC/SP) be changed?
The camera base attached to the bottom of the camera head can also be attached to the another side of the camera head. Remove the four screws (M1.4×5) from the base and re-attach the base to the another side of the camera head. (Recommended screw tightening torque: 0.15N·m)
The distance from the lens mount to plinth must note the change from the installation of top side or the bottom when you install it in side respect of plinth.
How is the mounting bracket used for the OMRON FZ-SPC camera head (FZ-SFC/SF)?
The mounting bracket of the FZ-SFC/SF attachment is fixed by screw(M2x4 Four) that is attached to camera head in the direction of figure below. (Recommended screw tightening torque: 0.1N·m)
What is the procedure for connecting the OMRON FZ-SPC camera head and camera amplifier?
Please do insert the front connector of camera amplifier with connector of camera head, turn the ring, and fix firmly.
What confirmation is needed before connecting the OMRON FZ-SPC camera head and camera amplifier?
Confirm the model and serial number of the camera amplifier and camera head is same, when connecting it. When the camera head and the camera amplifier of a different model and the serial number are connected, it doesn’t operate normally.
How is the camera amplifier connected to the camera cable for the OMRON FZ-SPC Small Digital Camera?
(1) Using the Camera cable FZ-VS (sold separately), connect the connector on the back of the camera amplifier and the camera connector on Controller FZ series.
The camera cable is polarized, so, make sure that the end bearing a name plate is connected to the Controller.
What are the general specifications for the OMRON FZ-SPC Small Digital Camera (FZ-SPC/SP Pencil type)?
| Item | FZ-SPC/SP |
|---|---|
| shape | Pencil type |
| Power consumption | 3.4W max.(13V DC,0.26A max.) |
| Vibration resistance | 10 to 150Hz: half-amplitude: 0.35mm: (maximum acceleration: 50m/s²), 10 times each in X, Y, and Z directions for 8 min |
| Shock resistance | Shock resistance 150m/s²; 3 times each in 6 directions (up/down, left/right, forward/backward) |
| Ambient Temperature (Camera head) | Operating: 0 to 50 °C (with no icing nor condensation) |
| Ambient Temperature (Camera amplifier) | Operating: 0 to 45 °C (with no icing nor condensation) |
| Ambient Temperature (Storage) | -25 to 65 °C (with no icing nor condensation) |
| Ambient humidity (Operating and storage) | 35% to 85% (with no condensation) |
| Ambient environment | No corrosive gases |
| Degree of protection | IEC60529 IP20 (in-panel) |
| Materials/Weight (Camera amplifier) | Cover: Galvanized sheet iron Case: Aluminum die cast alloy (ADC-12) Base: polycarbonate ABS 60g (including base) |
| Materials/Weight (Camera head) | Case: Aluminum alloy (A5056) Base: PC/Glass fiber Cap: Silicon rubber 70g (including base) |
What are the performance specifications for the OMRON FZ-SPC Small Digital Camera?
| Item | FZ-SFC/SPC | FZ-SF/SP |
|---|---|---|
| Picture element | 1/3-inch color CCD | 1/3-inch monochrome CCD |
| Transmission mode | Interline reading all pixels | |
| Effective pixels | 659(H)×494(V) | |
| Pixel size | 7.4(µm)×7.4(µm) (Square pixel) | |
| Scanning method | Non-interlace mode | |
| Frame rate | 80fps | |
| Number of lines to be read | 12 lines to 480 lines | |
| Synchronization | Internal Sync. | |
| Video output | Digital (10 bits) | |
| Gain | -6dB to + 24dB | |
| Shutter speed | 1/10 to 1/50000s | |
| Lens mounting | Special mount (M10.5 P0.5) | |
What are the specifications for the small lens and photograph ring used with the OMRON FZ-SPC Small Digital Camera?
| Item | FZ-LES3 | FZ-LES6 | FZ-LES16 | FZ-LES30 | FZ-LESR |
|---|---|---|---|---|---|
| Focal length | 3mm | 6mm | 16mm | 30mm | |
| Aperture | F2.0 | F3.4 | |||
| Materials | Lens: Optical glass Outline: Aluminum alloy (CB156) | Aluminum alloy (A5056) | |||
| Weight | Approx. 5g | Approx. 5g | Approx. 6g | Approx. 6g | Approx. 4g |
What are the dimensions (L) of the Small lens (FZ-LES optional) for the OMRON FZ-SPC Small Digital Camera?
| Model | L |
|---|---|
| FZ-LES3 | 16.4 |
| FZ-LES6 | 19.7 |
| FZ-LES16 | 23.1 |
| FZ-LES30 | 25.5 |
What are the dimensions of the Photograph ring (FZ-LESR optional) used with the OMRON FZ-SPC Small Digital Camera?
| Photograph Ring Length | Length (mm) |
|---|---|
| PHOTOGRAPH RING 5mm | 5 |
| PHOTOGRAPH RING 10mm | 10 |
| PHOTOGRAPH RING 15mm | 15 |
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
CLICK HERE TO DOWNLOAD OMRON FZ-SPC (01) PDF DOCUMENT