Free English OBJECTO H9 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD OBJECTO H9 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
What are the safety warnings for operating the OBJECTO H9?
To ensure safe operation of the OBJECTO H9, follow these warnings:
Do not disassemble the OBJECTO H9. This product may only be disassembled by qualified repair technicians to avoid fire, electrical shock, or injury.
Do not use the product if the power cord or plug is damaged, or if the plug is inserted loosely into the outlet, as this may result in a short-circuit, fire, or electrical shock.
Do not scratch, damage, modify, forcibly bend, pull, twist, or bind the power cord. Avoid placing heavy objects on or clamping the power cord.
Do not insert metal objects, such as pins or wires, or other foreign objects into the gaps of the product to prevent electrical shock or malfunction.
Do not allow children to use the product by themselves and keep it out of reach of small children to prevent burns, injury, or electrical shock.
Use the OBJECTO H9 only with the designated power supply of 110 – 120 V.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons to avoid a hazard.
What precautions should be taken when placing and using the OBJECTO H9?
Follow these usage and placement guidelines for the OBJECTO H9:
Unplug the product from the outlet before cleaning.
Do not use the unit in locations with humidity of 85% or higher.
Avoid placing the unit where the steam mist directly contacts furniture, walls, curtains, ceilings, or other objects.
Do not place the OBJECTO H9 on slanted surfaces, high locations like bookshelves, or unstable surfaces.
Do not block the mist outlet.
Use clean water only. Do not use hot water above 104 degrees Fahrenheit as it can cause deformation or malfunction.
Never put aroma oil or other fragrances directly into the water tank.
Do not place the product directly on a carpet or objects with soft fibers.
Do not wipe the unit with benzene or thinner.
Always unplug by grasping the power plug, not by pulling the cord.
Spill out the water when the product is not in use. Replace water in the tank and tub with clean water every day, and clean the unit weekly.
Place the product at least 7 feet away from televisions, radios, and other electronics to avoid static interference.
Do not tilt the product.
How do I prepare the remote control for the OBJECTO H9?
To insert the battery into the OBJECTO H9 remote control:
1. Turn the remote control over and hook your finger under the battery holder part to pull it out.
2. Insert a coin-shaped lithium battery (CR2025) with the positive (+) side facing up.
3. Slide the battery holder back in until it is pressed in all the way.
The remote control has a usable range of 17 feet in a straight line from the front of the humidifier and about 30 degrees to either side. Ensure there are no obstructions between the remote and the humidifier.
When not in use, the remote can be attached to the holder on the back of the humidifier cover.
How do I fill the water tank of the OBJECTO H9?
Follow these steps to fill the OBJECTO H9 with water:
1. Remove the cover from the top of the humidifier.
2. Remove the water tank from the humidifier body.
3. Unscrew the water tank cap and fill the tank with clean tap water at room temperature.
4. Firmly tighten the water tank cap, wipe up any spilled water, and check for leaks.
5. Set the water tank back into the humidifier so that it fits securely.
6. Put the cover securely back on the humidifier.
7. Plug the power cord into the outlet.
What are the required distances for placing the OBJECTO H9?
When positioning the OBJECTO H9, maintain the following minimum distances from surrounding objects:
At least 4 feet above the humidifier.
At least 1.5 feet in front of the unit.
At least 1.5 feet behind the unit.
At least 1.5 feet to the left and right sides of the unit.
Place the humidifier at least 7 feet away from televisions, radios, and other electronics.
How do I start and operate the mist settings on the OBJECTO H9?
To start the OBJECTO H9, press the Power/Mist Setting button. The mist level indicator will light up green, and the unit will begin producing mist after about 2 minutes. The water is heated to at least 140 degrees Fahrenheit for sterilization before misting begins.
To set the mist level, press the Power/Mist Setting button repeatedly to cycle through the options. Refer to the table below for indicator colors:
| Mist Setting | Mist Level Indicator Color |
|---|---|
| H (High) | Lit green |
| M (Medium) | Lit blue |
| L (Low) | Lit orange |
| SL (Super Low)* | Flashes orange |
*Timer function: When the mist level is set to SL (Super Low), the timer function is activated, and the power will automatically turn off after 5 hours.
To stop the humidifier, press the OFF button. The fan will continue to run for about 1 minute after misting stops before the unit comes to a complete stop.
How do I use the aroma case with the OBJECTO H9?
To use the OBJECTO H9 with aromatic fragrances:
1. Pull out the aroma case from the humidifier body.
2. Ensure the felt is inserted in the case. Drop two or three drops of aroma oil or essential oil onto the felt. Do not overfill.
3. Place the felt under the tabs in the aroma case so it does not stick up and get caught during insertion.
4. Insert the aroma case all the way back into the humidifier.
5. Start the humidifier as normal. If no oil is added, the unit functions as a regular humidifier.
Replace the felt whenever it becomes dirty or when changing scents. The felt cannot be washed and reused.
How should I clean the OBJECTO H9?
Cleaning should be performed at least twice a week. Before cleaning, stop operation, unplug the power cord, and let the unit cool for about 10 minutes.
Cleaning the body: Wipe with a soft cloth dipped in warm water and/or mild dish detergent. Dry with a soft cloth. Do not rub hard on plastic parts.
Draining water: Always drain water in the direction indicated by the arrow on the humidifier body. Draining in other directions may allow water into the fan outlet and cause malfunction.
Cleaning the water tank: Fill the tank with room temperature water, close the cap, shake thoroughly, and drain. Repeat two or three times. Do not use hot water, cleansers, benzene, or thinner.
Cleaning the aroma case: Use a vacuum cleaner to remove dust from the air inlet. Wash the filter in the aroma case with water, but do not rub or wring it too strongly.
Water passage cover: Ensure the water passage cover is always reattached correctly after cleaning. Insert the tabs into the grooves completely to prevent hot water overflow.
How do I troubleshoot common problems with the OBJECTO H9?
If you encounter issues with the OBJECTO H9, refer to the following troubleshooting table:
| Problem | Primary Cause | Solution |
|---|---|---|
| The power does not turn on. | The power cord is not plugged into the outlet. | Plug the power cord into the outlet. |
| No or very little mist is produced. | The Water indicator is lit red. | Fill with water. Wait about 2 minutes for water to heat for sterilization. |
| No or very little mist is produced. | The ceramic disc must be replaced (expected life 3,000 hours). | Contact the service center for replacement. |
| The Water indicator stays lit red even when water is supplied. | The water tank is not mounted securely. | Load the water tank so that it fits properly. |
| An odor is emitted. | Using water other than clean water. | Drain the water and clean the unit according to the Cleaning and Storage procedures. |
| The mist seems like it stops every 20 seconds. | Normal operation to prevent water accumulation. | The fan motor cycles for at least 2 seconds every 20 seconds; this is not a malfunction. |
What are the technical specifications of the OBJECTO H9?
| Product name | OBJECTO H9 Tower Hybrid Humidifier |
| Model | HM-54 |
| Power supply | 110 – 120 V, 50/60 Hz |
| Rated consumption | 80 W |
| Mist production per hour | H (High): Approx. 0.64 pints; M (Medium): Approx. 0.50 pints; L (Low): Approx. 0.31 pints; SL (Super Low): Approx. 0.20 pints |
| Continuous humidifying time | Approx. 8 hrs (High); 11 hrs (Medium); 18 hrs (Low); 28 hrs (Super Low) |
| Tank capacity | Approx. 0.69 gallons |
| Power cord length | Approx. 6 feet |
| External dimensions | Approx. 9 inches Diameter x 34 inches Height |
| Weight | Approx. 5 lb (body only) |
| Included Accessories | User’s Manual, Remote control, CR2025 battery, Replacement felt x 2 |
CLICK HERE TO DOWNLOAD OBJECTO H9 (01) PDF DOCUMENT