O3WATERWORKS SB-100HD (01) PDF MANUAL


Post questions, comments, reviews or errors in the comment box below.

Your File is Ready … Download PDF

CLICK HERE TO DOWNLOAD O3WATERWORKS SB-100HD (01) PDF MANUAL


PDF Content Summary: ENHANCED OXYGEN SPRAY BOTTLE clean with the power of natureUSER MANUAL Model: SB-100HD

CONTENTS 1 Safety ...............................................................................................3 1.1 Symbols from the User Manual ...................................... 3 1.2 Proper Use.............................................................................. 3 1.3 Caution .................................................................................... 3 1.4 Important Instructions....................................................... 3 2 Technical Data ..............................................................................4 3 Safety ...............................................................................................5 3.1 Description.............................................................................5 3.2 Key Components ................................................................. 5 3.3 Operating Instructions....................................................... 6 4 Preventative Maintenance / Cleaning ................................8 5 Troubleshooting...........................................................................8 5.1 Indicator Lights on Top of Bottle .................................. 8 5.2 Battery Replacement ......................................................... 8 6 Decommissioning........................................................................9 6.1 Storage....................................................................................9 6.2 Disposal...................................................................................9 7 Service ...........................................................................................10 7.1 Service and Warranty ...................................................... 10 7.2 Service Network – U.S. & Canada................................ 10 SAFETY IMPORTANT! Before initial use, the instructions on operating safety, use and maintenance must be read carefully and understood. Keep the user manual in the vicinity of the appliance for later reference. 1.1 SYMBOLS FROM THE USER MANUAL CAUTION CAUTION indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. NOTICE NOTICE indicates a situation which, if not avoided, may result in damage to the appliance. Important information can be found here. 1.2 PROPER USE The O3waterworks Enhanced Oxygen Spray Bottle is intended for residential use. It is designed for safe operation when used as directed. The following general safety precautions provide guidance for safe use. Failure to comply with the safety precautions or warnings indicated in this manual violates the safety standards of this equipment. The manufacturer and distributer assumes no liability for the user’s failure to comply with these requirements. • Read manual before use. • It may only be used for its intended purpose. • Product is intended for residential use. • Fill with clean, potable water only. • Do not immerse unit in water. Clean exterior of unit with soft cloth. Do not use harsh or abrasive cleaners. • Do not add any cleaning chemicals into the water reservoir. Do not spray toward eyes. In case of eye exposure rinse a ected eye(s) thoroughly with clean water for 5 to 10 minutes. If irritation persists, seek medical attention. • Use only properly ventilated area in conformance to all local and national regulations.

• Do not remove warning labels from unit. 1.3 CAUTION • If overly strong odor of ozone is detected discontinue use. • If respiratory irritation is experienced discontinue use immediately. • Do not expose plastic sprayer to extreme heat or open flame. • Keep out of the reach of children. • Do not drop sprayer. 2 3 SAFETY (cont’d) 4 1.4 IMPORTANT INSTRUCTIONS NOTICE To avoid appliance damage: Do not drop the bottle. – Dropping the bottle may cause breakage. Fill with clean potable water only. – Filling the bottle with fluids other than clean potable water may damabe cartridge and render the product useless. Do not overfill the bottle. – Overfilling may cause leakage at the fill plug. Do not run water into the charger port. – Doing so may short the battery/electronics. TECHNICAL DATA SPECIFICATIONS Materials Weight (empty) Dimensions (in mm) Reservoir Capacity Water Temperature Water Quality Ambient Air Rechargable Battery Useful Battery Life Model # Certifications EPA Establishment Number 5 PC/ABS Impact Resistant Plastic ~ 2 lb (0.9 kg) 4 in x 4 in x 10 in (100 mm x 100 mm x 250 mm) 14 oz (400 ml) 40°F to 86°F (4°C to 30°C) Hardness ≤ 250 ppm CACO3 (May Extend Life of Unit) Conductivity >50 S/cm (Cell damage may result from use of distilled or deionized water) 40°F to 104°F (4°C to 40°C) 7.4 V Li-lon (Charger uses 100 V AC to 240 V AC, 50/60 Hz) 5000 Reservoir Fills or 500 Charges (Typical) SB-100 CE, TUV, RoHS, WEEE 089373-MA-001 Water DESCRIPTION Based Sanitizer • Proven sanitizer • Reduces common pathogens • Destroys odor-causing microorganisms • Ensures e cacy and compliance with EPA requirements 3.1 DESCRIPTION Dependable, On-Demand Solution The O3waterworks Enhanced Oxygen Spray Bottle o ers a water-based alternative to tradtional cleaners and sanitizers. It turns potable water into aqueous ozone, a sanitizer that kills many common pathogens found on hard, non-porous surfaces and destroys organic odors. • Ozone (O3) is activated as-needed • Runs on long lasting rechargeable batteries • Requires only clean, potable water • User-friendly lights indicate when sanitizer is active The tiny electrolytic cell is created from a proprietary diamond process technology and generates ozone on-demand from water itself. Water exists in Alternative the reservoir and the ozone is activated on-demand, creating the sanitizer. This • Leaves behind no residues eliminates the need for many household chemicals and the constant need to • Compatible with all surfaces where water may be used repurchase supplies. Furthermore, it leaves no residue. • Eliminates potential errors with mixing or diluting • Ingredients by weight: – 99.9998% Water – 0.0002% Ozone – No fragrance added 3.2 KEY COMPONENTS 1. Indicator LEDs 13.3 OPERATING INSTRUCTIONS 2. Charging Port IMPORTANT: Please read these instructions completely before use. 3. Spray Nozzle 24. Diamond Cell 3 Use this product to sanitize hard, non-porous, non-food contact surfaces. • Tables and countertops • Doors and handles 5. Spray Trigger • Kitchen surfaces • Pet accident odors 6. Fill Plug 4• Bathroom surfaces • Windows 7. Water Reservoir Product should only be used on surfaces that have been identified to be 8. Battery & Control Electronics 5 at risk for disease transmission or where required by regulation. 6 Charge the Unit Before using the sprayer for the first time, charge the batteries. The first charge may take up to 8 hours. The red light on the charger indicates that the device is being charged. The charge is complete when the 7light on the charger is green. Charge plug location NOTE: The spray bottle will not operate while connected to the battery charger. 8 Connect the battery charger to a 100-240 V AC 50/60 Hz power source. Connect the battery charger power cord to the spray bottle. The system is powered by a 7.4 V NOTE: Product may vary from illustrations Lilon rechargeable battery pack. A 100 to 240 V AC 50/60 Hz charger is included. After Charging, it is important to securely User only the charger provided. push protective flap back in place. 6 7

Fill the Reservoir Remove the fill cap to fill the reservoir with 10 oz of clean, cold potable water. While holding the unit in the horizontal position, fill reservoir about half full. Securely replace the fill plug. Turn bottle in vertical position and check fill line. Repeat until water reaches fill line. Do not overfill. Do not fill with hot water. CAUTION FILL WITH CLEAN, COLD POTABLE WATER ONLY. DO NOT OVERFILL THE BOTTLE. DO NOT RUN WATER INTO THE CHARGER PORT. WATER TEMPERATURE 40°F to 86°F (4°C to 30°C) Prime the Spray Bottle When new, or after long storage, the ozone generator in the head of the bottle may become de-primed. When the ozone cell is dry, the blue light will not illuminate while spraying. A primed spray bottle should spray uninterrupted for at least 30 seconds with the blue light illuminated. To prime the spray bottle, continue to spray with the blue light o until the blue light turns on. If the blue light does not illuminate after 2 minutes of spraying, the bottle may need to be primed using salt. Additionally, if the bottle starts spraying with the blue light illuminated and then stops spraying with the blue and red lights then flashing twice, your bottle may need to be primed using salt. To prime the spray bottle with salt: 1. Fill the spray bottle with water 2. Add 1 tsp of regular table salt 3. Spray the full tank into the sink 4. Fill the spray bottle with fresh tap water 5. Your bottle is now ready to use Please note: the ozone cell may need to be re-primed with 1 tsp of salt if unit is unused for 3 or more months. 8 While spraying, blue light indicates unit is working properly. Hold 6-8” away from surface. Sit bottle on counter and check water level with fill line. Secure fill plug. Fill approximately half full in horizontal position. Remove cap. Sanitize Hard Non-Porous Surface Hold the spray bottle 6 to 8 inches from the surface and spray evenly until wet. For 99.9% e ectiveness against common pathogens allow to stand for 30 seconds. Wipe with a clean cotton or microfiber cloth or allow to air dry. No rinsing is necessary (leaves no residue). Ozone is generated on demand. While spraying, the blue indicator will light when the unit is operating properly. Hold the spray bottle 6 to 8 inches from the surface and spray evenly until wet. For 99.9% e ectiveness against common pathogens allow to stand for 30 seconds. Wipe with a clean cotton or microfiber cloth or allow to air dry. No rinsing is necessary (leaves no residue). Ozone is generated on demand. While spraying, the blue indicator will light when the unit is operating properly. PREVENTATIVE MAINTENANCE & CLEANING 2. Clean bottle with moistened cloth only. Do not use chemicals or cleaners. TROUBLESHOOTING TROUBLESHOOTING 5.1 INDICATOR LIGHTS ON TOP OF BOTTLE LIGHTED INDICATORS SYSTEM MESSAGE LIGHTED INDICATORS SYSTEM MESSAGE SOLID BLUE ONE RED FLASH TWO RED FLASHES THREE RED FLASHES TWO RED & BLUE FLASHES ALL OTHER PROBLEMS System is operating properly System is operating properly Battery is low Battery is low Reservoir is empty Reservoir is empty Battery needs recharging Battery needs recharging System fault; recharge and try again. If error persists, contact service department. System fault; recharge and try again. If error persists, contact service department. System fault; recharge and try again. If error persists, contact service department. Contact service department. Contact service department. The battery can be replaced. Detailed instructions are included with the replacement battery kit. A replacement battery can be ordered through your dealer where you purchased this product, or through the Service Department as listed in Section 7 of this manual. 9

1. Charge unit nightly to ensure full capacity the next day. 5.2 BATTERY REPLACEMENT 10 12

DECOMMISSIONING (STORAGE/DISPOSAL) 6.1 STORAGE Empty tank through the fill plug. Do not spray empty. Leave fill plug open to allow tank to dry. 6.2 DISPOSAL Disassembly of the appliance must be performed by qualified specialists according to the manufacturer’s instructions. – Follow the local safety regulations. – Dispose of the appliance in accordance with local regulations. – It is essential that you observe the laws and regulations for the disposal of environmentally harmful substances. Obtain detailed information about their disposal – such substances include plastics and decommissioned battery packs and Li-lon battery. Special regulations apply when disposing of used electrical appliances: The customer assumes responsibility for proper disposal of the delivered product after the end of its service life at the customer’s own expense, in accordance with legal regulations. SERVICE 7.1 SERVICE & WARRANTY The manufacturer warrants new equipment to be free of defects due to poor materials or workmanship for the period of time listed below (following the date of original installation): • One year replacement Exclusions: Certain O3waterworks parts that are expendable by nature and that need to be replaced frequently may not be covered. O3waterworks is not liable under these warranties for repairs or damages due to improper operation, attempted repairs or installation by unauthorized persons, alterations, abuse, fire, flood, or acts of nature. Additionally, this warranty may be voided in the case of: • Failure to follow instructions for use, care or maintenance • Service by a non-authorized service company • Mechanical damage • Use with any other fluids other than clean, potable water This warranty is conditional upon receiving notice of any defect subject to this warranty within thirty (30) days of its original discovery by the Buyer. For service or warranty questions, contact customer service. 7.2 SERVICE NETWORK support@o3waterworks.com

• Removal, alteration or defacing of the serial number and other labels Distributed by: o3waterworks, LLC. 207 Byers Creek Road, Unit D Mooresville, NC 28117 Manufactured by: Enozo Technologies 300 Willow Street North Andover, MA 01845 EPA Est. No. 089373-MA-001 For support, contact: service@o3waterworks.com Model: SB-100HD


FREE ENGLISH PDF

OPERATING INSTRUCTIONS

USER GUIDE - USER MANUAL

OWNER GUIDE - OWNER MANUAL

REFERENCE GUIDE - REFERENCE MANUAL

INSTRUCTION GUIDE - INSTRUCTION MANUAL

Leave a Reply