Free English NEC VT470 (02) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD NEC VT470 (02) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
What should I do if I encounter problems while setting up or using the NEC VT470?
If you encounter problems while setting up or using the NEC VT470, see “Troubleshooting” in the user’s manual on the supplied CD-ROM or the Important Information.
How do I connect the supplied signal cable to the NEC VT470?
Connect the supplied 15pin-15pin signal cable.
For older Macintosh computers, use a commercially available pin adapter to connect to your Macintosh’s video port.
How do I connect the power cable to the NEC VT470?
Connect the supplied power cable.
How do I turn on the main power switch for the NEC VT470?
To turn on the main power to the NEC VT470, press the Main Power switch to the on position (1).
The NEC VT470 will go into its standby mode and the power indicator will glow orange.
How do I turn on the projector power for the NEC VT470 after turning on the main power?
To turn on the power to the NEC VT470, press and hold the ON/STAND BY button on the projector cabinet or the POWER ON button (POWER button on VT570/VT47) on the remote control for a minimum of 2 seconds.
How do I select a source on the NEC VT470?
Turn on the computer.
Press the COMPUTER 1 or COMPUTER 2 button on the remote control. (SOURCE button on VT570/VT47)
NOTE: Optimizing RGB image automatically.
Press the AUTO ADJ. button on the projector cabinet to optimize an RGB image automatically.
How do I adjust the tilt foot on the NEC VT470?
Push up and hold the Adjustable Tilt Foot Button on the front of the projector to extend the adjustable tilt feet (maximum height).
How do I adjust the image size and focus on the NEC VT470?
Zoom: Use the Zoom lever to finely adjust the image size on the screen. On VT47, use the Digital ZOOM button on the projector cabinet.
Focus: Use the Focus ring to obtain the best focus.
How is the Auto Keystone Correction feature used on the NEC VT470?
The Auto Keystone correction feature will correct the vertical distortion of a projected image on the screen.
No special operation required. Just put the projector on a flat surface.
CLICK HERE TO DOWNLOAD NEC VT470 (02) PDF DOCUMENT