MR BEAMS MB300 (01) PDF MANUAL

MR BEAMS MB300 (01) PDF SUMMARY:

How do you unscrew the thumbscrew on the mounting bracket?

Unscrew the thumbscrew on the mounting bracket by turning counter-clockwise.

---

How do you unlock the bracket from the keyhole?

Push the bracket down toward the light to unlock from the keyhole.

---

What should you do after you unlock the bracket from the keyhole?

Gently pull up on the post side of the bracket and lift off of the light.

---

How do you remove the front cover of the spotlight to reveal the battery holder?

Remove the front cover of the spotlight by unscrewing counter-clockwise. Pull face from cup to reveal the battery holder.

---

How do you release the battery door?

Push down on the battery door tab to release.

---

How do you insert the C-cell batteries?

Insert 3 C-Cell batteries, with the flat side to the spring.

---

How do you attach the battery door?

Attach the battery door by inserting tabs into the rectangular holes then push down on front until door clicks into place.

---

How do you screw the face of the spotlight back into the cup?

Screw the face of the spotlight back into the cup by turning clockwise 3 full rotations until tightly closed.

---

How do you mount the spotlight?

First, slide the post into the bracket, then slide down to the locked position. Align the opposite end with the screw to the hole.

---

How do you determine the mounting location?

Determine the mounting location and drive two screws directly through two holes in the mounting bracket.

---

How do you lock the light in the preferred angle?

Choose the preferred angle of the light, then tighten the thumbscrew to lock in position.

---

What type of batteries should you use for best results?

For best results, use type Alkaline C-Cell batteries with a 1.5V rating.

---

What should you do when installing batteries?

Install only new batteries of the same type in your product.

---

What can happen if the batteries are not inserted in the correct polarity?

Failure to insert batteries in the correct polarity, as indicated in the battery compartment, may shorten the life of the batteries or cause batteries to leak.

---

Should you mix old and new batteries?

Do not mix old and new batteries.

---

Should you mix different types of batteries?

Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable (Nickel Cadmium) or (Nickel Metal Hydride) batteries.

---

Should you dispose of batteries in a fire?

Do not dispose of batteries in fire.

---

How should batteries be disposed of?

Batteries should be recycled or disposed of as per state and local guidelines.

---

What should you do if the light activates when the batteries are first inserted?

Light may activate when batteries are first inserted. Simply take the light into a dark room, allow the batteries to settle, then test activation.

---

What is included per light?

• 1 Wireless Spotlight
• 1 Mounting Bracket
• 2 Screws
• 2 Anchors
• 1 Small Screwdriver
• 3 C-Cell Alkaline Batteries
• Mounting Bracket
• Post Mounting Bracket Thumb Screw
• Motion & Light Sensor
• LED Light

---

What are the spotlight features?

• Motion/Light Sensor: Light instantly turns on when it detects motion from up to 25 feet away. The light sensor conserves battery life by preventing the light from activating in daylight.
• Auto Shut-off: Light shuts off automatically after 30 seconds if no motion is detected.
• Adjustable: Bracket allows light to angle up or down.
• Bright LED: 80 lumens covers up to 350 sq ft.
• Durable, Weather Resistant: Tight seals and UV resistant material allow the light to work in all weather conditions.

---

When will the light sensor allow the spotlight to activate?

The light sensor only allows the spotlight to activate in darkness.

---

How do you test the light?

Test in a dark room or closet.