MIBOXER FUT070 (01) PDF MANUAL

MIBOXER FUT070 (01) PDF SUMMARY:

How do you install the 12W Anti-glare RGB+CCT LED Downlight?

Open a hole in the ceiling according to the correct size. Connect the driver properly according to the wire connection diagram. Put the driver and wire into the ceiling from the hole. Push in the two spring elements, making sure that they are deployed and anchored on the back of the ceiling.

What size hole should I cut in the ceiling for the 6W downlight?

The hole size should be ø80-85mm.

What size hole should I cut in the ceiling for the 12W downlight?

The hole size should be ø95-100mm.

What is the control distance of the remote?

The remote control distance is 30m.

What remote controls are compatible with the downlights?

The downlights are compatible with FUT089, FUT088, FUT092, FUT096, B8, B0, B3 / T3, B4 / T4, and WL-Box1 remote controls.

What should I do before operating the lights?

The lighting can be operated after linking with a remote control. Refer to the remote instructions for more details.

What are the dynamic modes available for the downlights?

The dynamic modes are: Mardi Gras, Automatic color change, Sam, Gemstone, Twilight, American, Fat Tuesday, Party, and Slow Color Splash.

What can be adjusted in dynamic mode?

You can adjust the Brightness, Saturation, and Speed in dynamic mode.

What does “Modes synchronization” mean?

Different downlights can work synchronously when they are started at different times, controlled by the same remote, under the same dynamic mode, and within a 30m distance.

How does “Signal transmitting” work?

One downlight can transmit the signals from the remote control to another downlight within 30m, so the remote control distance can be limitless as long as there is a downlight within 30m.

What safety measures should I take before installing the lights?

Switch off the power before installing the lighting fixtures. Check whether the input voltage supply is in accordance with the lighting fixtures. Do not dismantle the lighting fixtures directly if you are not a professional, as it may cause fire and electric shock.

What areas should I avoid using the lighting fixtures around?

Do not use the lighting fixtures around mental areas and high magnetic fields, as it will badly affect the control distance.