MAYTRONICS NIYA SONAR F3 (01) PDF MANUAL

MAYTRONICS NIYA SONAR F3 (01) PDF SUMMARY:

How do I charge the robot for first-time use?

Charge the robot until the flashing green LED becomes solid.

---

How do I activate the robot for first-time use?

Unplug the charger and press the button on the robot to activate.

---

How do I use the robot in the pool for first-time use?

Put the robot in the pool until it finishes cleaning.

---

How do I remove the robot from the pool for first-time use?

1. Attach the hook to a pole and pull the robot to the waterline.
2. When the robot reaches the waterline, pull it out of the water with your hand.

---

How do I turn the robot OFF for first-time use?

Press and hold the button until the voice indicator says, “Goodbye”.

---

How long does the pool cleaner clean for in the cleaning mode?

The pool cleaner cleans the floor, walls, and waterline for up to 2 hours.

---

How do I prepare the pool cleaner for cleaning?

Place the pool cleaner on a solid surface at the poolside and make sure it is switched OFF.

---

How do I clean the pool cleaner?

1. Remove the robot lid.
2. Take out the filter basket.
3. Remove the filter lid.
4. Clean the basket.

---

How do I store the pool cleaner for a long time?

1. Make sure there is no water left in the pool cleaner.
2. Thoroughly clean the filter basket and insert it back in place.
3. Store the pool cleaner in a protected area away from direct sunlight/rain/frost at a temperature between 0°−40°C / 32°−104°F.
4. Charge the pool cleaner once every 3 months to protect the battery.

---

What should I do if there is any physical damage to the pool cleaner or charger?

Contact Customer Care for instructions.

---

What should I do when removing the robot from the pool?

Set it on the edge to empty the water before lifting.

---

What do the LED indicators mean?

• Blue Solid: Device Working
• Blue Flashing 1 sec: Device Starting
• Blue Flashing 3 secs: Device Idle
• Red: Device Error
• Green Solid: Fully Charged
• Green Flashing: Device Charging
• Yellow: Low Battery
• Purple: Device Stuck During Operation
• White: Software Update

---

What does it mean when the red LED indicator starts flashing and the robot announces a “Pumping motor issue?”

The likely cause could be a clogged impeller, which causes the robot to struggle to vacuum and climb even if the filter is clean.

---

How do I turn OFF the robot before cleaning the impeller?

Press and hold the button until there is a voice indication, “Goodbye”.

---

What do I need to ensure before cleaning the impeller?

Ensure the metallic out-of-water sensors are completely dry by wiping with a tissue or towel.

---

How do I clean the impeller?

1. Turn OFF the robot by pressing and holding the button until you hear the “Goodbye” voice indication.
2. Ensure the metallic out-of-water sensors are completely dry by wiping with a tissue or towel.
3. Remove 2 screws to take off the impeller cover.
4. Carefully remove debris from the impeller area with tweezers or a similar tool. Gently return the cover and screws.