MAKITA DC07SA (01) PDF MANUAL

The following symbols are used:

Plug symbol: Ready to charge

Battery symbol (partially filled): Charging

100% symbol: Charging complete

Thermometer symbol: Delay charge (too hot battery)

Battery with X symbol: Defective battery

Crossed terminals symbol: Do not short batteries.

Model: DC07SA

Input: A.C. only 50 Hz – 60 Hz

Output: D.C. 7.2 V

Weight: 0.354 kg (0.77 lbs)

1. SAVE THESE INSTRUCTIONS – This manual contains important safety and operating instructions for the battery charger.

2. Before using the battery charger, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using the battery.

3. CAUTION – To reduce risk of injury, charge only MAKITA rechargeable batteries marked on the charger label. Other types of batteries may burst causing personal injury and damage.

4. Non-rechargeable batteries cannot be charged with this battery charger.

5. Use a power source with the voltage specified on the nameplate of the charger.

6. Do not charge the battery cartridge in the presence of flammable liquids or gases.

7. Do not expose charger to rain or snow.

8. Never carry charger by cord or yank it to disconnect from receptacle.

9. After charging or before attempting any maintenance or cleaning, unplug the charger from the power source. Pull by plug rather than cord whenever disconnecting charger.

10. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.

11. Do not operate charger with damaged cord or plug – replace them immediately.

12. Do not operate or disassemble charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified serviceman. Incorrect use or reassembly may result in a risk of electric shock or fire.

13. The battery charger is not intended for use by young children or infirm persons without supervision.

14. Young children should be supervised to ensure that they do not play with the battery charger.

15. Do not charge battery cartridge when temperature is BELOW 10°C (50°F) or ABOVE 40°C (104°F).

16. Do not attempt to use a step-up transformer, an engine generator or DC power receptacle.

1. Plug the battery charger into the proper AC voltage source. The charging light will flash in green color.

2. Insert the battery cartridge so that the plus and minus terminals on the battery cartridge are on the same sides as their respective markings on the charger.

3. When the battery cartridge is inserted fully, the charging light will change from green to red and charging will begin. The charging light will remain lit steadily during charging.

4. When the charging light changes from red to green, the charging cycle is complete.

5. After charging, unplug the charger from the power source.

Refer to the table for the charging time below.

Battery type	Voltage	Number of cells	Capacity (Ah)	Charging time (minutes)
Li-ion battery cartridge	7.2 V	2	1.0	30
		BL7010	1.0	30

The battery charger is for charging Makita battery cartridge. Never use it for other purposes or for other manufacturer’s batteries.

When you charge a battery cartridge which is new or has not been used for a long period of time, it may not accept a full charge until after discharging it completely and recharging a couple of times.

If you charge a battery cartridge from a just operated tool or a battery cartridge which has been exposed to direct sunlight or heat for a long time, the charging light may flash in red color. If this occurs, wait for a while. Charging will begin after the battery cartridge cools. This indicates a “Delay charge (too hot battery)”.

If the charging light flashes alternately in green and red, charging is not possible. The terminals on the charger or battery cartridge are clogged with dust or the battery cartridge is worn out or damaged.