Free English LYNGDORF W210 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD LYNGDORF W210 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
Where should I place the LYNGDORF W210 BassDirect speaker for the best sound?
The LYNGDORF W210 BassDirect speaker is specifically built to stand in a corner. If you have a rectangular room, experience suggests that you get the best sound if they are placed along the longest wall. This will give you a wider stereo image than if they are placed along the short wall.
How should I position my main speakers when using the LYNGDORF W210?
Place your main speakers the way you would place them normally. It is not necessary to place them close to the LYNGDORF W210s. If applying RoomPerfect, you can even place the main speakers up against the back wall.
How do I connect the LYNGDORF W210 to an amplifier?
When connecting the LYNGDORF W210s, always connect “+” and “-” from the amplifier to the corresponding “+” and “-” terminals on the LYNGDORF W210 input. Connect your speakers the same way to avoid phase errors.
What is the recommended cut-off frequency for the LYNGDORF W210?
To match most speakers’ bass response, a cut-off frequency at 400Hz is recommended. However, depending on your speakers and room, the cut-off frequency can easily vary from 200-800Hz. Try experimenting to get the best sound.
How do I adjust the volume level of the LYNGDORF W210?
Adjust the level of the LYNGDORF W210s to match the sound level of your main speakers. If applying RoomPerfect, you can set the volume of the LYNGDORF W210s a few dB too loud before making the RoomPerfect calibration. RoomPerfect will then lower the bass to an appropriate level.
What is the proper way to clean the LYNGDORF W210?
Please use a dust-free cloth to clean the speakers. It is also possible to use a slightly damp cloth for more stubborn marks. Under no circumstances should you use any kind of cleaning agent on, or in close proximity to, these speakers.
What are the technical specifications for the LYNGDORF W210?
| Product | W210 |
| Woofer/midrange driver | 2 x 10” |
| Frequency response | 16 – 3500 Hz |
| Sensitivity (2.83V/1m) | 96dB |
| Nominal Impedance | 8 Ohm |
CLICK HERE TO DOWNLOAD LYNGDORF W210 (01) PDF DOCUMENT