LIKO HANDYBELT 3760015 (01) PDF DOCUMENT

The LIKO HANDYBELT 3760015 is used for transfer support. Most commonly, the belt is applied on the patient, and the caregiver then uses the belt as an aid in the transfer. Alternatively, it can be applied on both the patient and caregiver so that the patient can also use the belt as support when transferring.

Transferring a patient always involves a certain level of risk. Read the instructions for use before use. It is important to completely understand the contents of the instructions for use. The equipment should only be used by trained personnel. Ensure that the accessory is suitable for the transfer. Exercise care and caution during use. As a caregiver, you are always responsible for the patient’s safety. You must be aware of the patient’s ability to make it through the transfer. If something is unclear, contact the manufacturer or supplier.

Before use, keep the following points in mind:

• Plan the transfer operation so that it can be done as safely and smoothly as possible.

• A responsible person within your organization should decide on a case-by-case basis whether one or more caregivers are needed.

• The patient should understand and follow the instructions so he/she can be guided to a natural pattern of movement during raising.

• The patient should have head and torso stability and be able to sit upright. When gait training, it is also important that the patient has good balance when standing and the ability to move his/her feet independently when walking.

• Before transferring, check that the LIKO HANDYBELT 3760015 is applied correctly.

• The LIKO HANDYBELT 3760015 is not a lifting aid and the handles are not intended for lifting purposes.

• To minimize the strain for the caregiver, in case the patient should fall, it is important that the caregiver does not by his/her own efforts try to keep the patient in a standing position. Instead, we recommend that the caregiver, in a smooth motion, lower the patient to the floor. Remember to let go of the handles to avoid injuries to the caregiver’s hands caused by crushing.

• Always work ergonomically. Use the patient’s ability to actively participate in the operations.

The LIKO HANDYBELT 3760015 is intended for raising from sitting to standing, transfer from sitting to sitting, and support for standing/walking.

Application: Place the belt around the patient’s waist. Thread the strap through the buckle and pull it to tighten securely.

Removal: Press the release mechanism on the buckle to loosen and remove the belt.

Check the product before each use. Check the following points with regard to wear and damage:

• Fabric

• Straps

• Seams

• Handles

• Safety buckle

Do not use damaged products. If anything is unclear, please contact the manufacturer or supplier.

For washing instructions, please see the product label. The symbols on the label relate to the following instructions:

• Washing: Symbol is always in combination with recommended temperature in °C and °F.

• Do not bleach

• Tumble drying

• Do not tumble dry

• Line drying in shade

• Do not iron

• Do not dry clean

Per the Instructions for Use, this product should be inspected regularly, especially after it has been washed. Pay particular attention to wear and damage to seams, straps/handles, fabric, and/or fabric properties. When used in accordance with these instructions and following the instructions for Care and Maintenance, the LIKO HANDYBELT 3760015 will have a continuous useful life so long as the product passes inspection.

The entire product should be sorted as Combustible waste.

Customers should adhere to all federal, state, regional, and/or local laws and regulations as it pertains to the safe disposal of medical devices and accessories.

The LIKO HANDYBELT 3760015 is a Medical Device Class I Product with the following specifications:

Material: polyester. Fabric in Handybelt is made of non-flame retardant materials.

Each handle on the LIKO HANDYBELT 3760015 can withstand a load up to 30 kg / 66 lbs.

These symbols can be found in the document and/or on the product: