LIFEME MBLU BLUS+ (BLUSPLUS) (01) PDF Document

The package for the LIFEME MBLU BLUS+ (BLUSPLUS) includes the following items:

• Earphones x 2

• Charging case x 1

• Eartips (L/S) x 2

• Owner’s manual x 1

To charge your LIFEME MBLU BLUS+ (BLUSPLUS), place the earbuds in the case. Connect the case with a USB-C cable or place it on a wireless charger. For the first time use, please charge for at least 10 minutes.

The power indicator shows the charge level as High, Medium, or Low.

To connect your LIFEME MBLU BLUS+ (BLUSPLUS) to a mobile device, follow these steps:

1. Turn on Bluetooth on your phone or other device.

2. With the mblu Blus+ in the case and the lid open, press the button in the case until the light blinks. Then go to your device’s Bluetooth settings and choose mblu Blus+.

To change the ear tips on your LIFEME MBLU BLUS+ (BLUSPLUS):

1. Pull firmly to remove the current tip.

2. To attach a new tip, align it, then push until it clicks.

Choose the most comfortable fit for your ears. For more tip sizes, see inside the box.

The touch controls for the LIFEME MBLU BLUS+ (BLUSPLUS) are as follows:

• Answer/End a call: Double-press either earbud.

• Next song: Triple-press the right (R) earbud.

• Previous song: Triple-press the left (L) earbud.

• Turn on/off Noise Cancellation mode: Press and hold the right (R) earbud.

• Turn on/off Transparency mode: Press and hold the left (L) earbud.

• Switch between “Game mode” and “Music mode”: Long press the left (L) and right (R) side buttons at the same time.

1. This product contains a built-in lithium battery. Do not expose the product to strong sunlight or fire or it might explode. Dispose of the battery according to local regulations. Do not dispose of it as domestic waste.

2. Do not remove or replace the product battery unless doing so is specified in the User Manual or in the Quick Start Guide, or you might damage the product. CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.

3. Do not disassemble or refit the earphone for any reason as you may damage it or void the warranty.

4. Avoid contact with liquid to avoid serious damage to the earphone. The manufacturer does not cover water damage.

5. Avoid temperatures above 75 degrees and below minus 40 degrees.

6. Keep the indicator light away from children’s and animals’ eyes.

7. Do not use this product during thunderstorms to avoid electric shocks.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition, compliance with exposure requirements.