LG V-WP168NT (01) PDF Document

When using an electrical appliance like the LG V-WP168NT, basic precautions should always be followed to reduce the risk of fire, electric shock, or injury. Please read all instructions before use.

1. Do not leave the appliance when plugged in. Unplug it from the outlet when not in use and before servicing.

2. Do not use the vacuum outdoors or on wet surfaces.

3. Do not allow the appliance to be used as a toy. Close attention is necessary when it is used by or near children.

4. Use the appliance only as described in the manual. Use only manufacturer’s recommended attachments.

5. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or a similarly qualified person to avoid a hazard.

6. Do not pull or carry by the cord, use the cord as a handle, close a door on the cord, or pull the cord around sharp edges or corners. Do not run the appliance over the cord. Keep the cord away from heated surfaces.

7. Do not unplug by pulling on the cord. To unplug, grasp the plug, not the cord.

8. Do not handle the plug or appliance with wet hands.

9. Do not put any object into openings. Do not use with any opening blocked; keep it free of dust, lint, hair, and anything that may reduce air flow.

10. Keep hair, loose clothing, fingers, and all parts of the body away from openings and moving parts.

11. Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.

12. Do not use without the dust filter and/or clean filter in place.

13. Turn off all controls before unplugging.

14. Use extra care when cleaning on stairs.

15. Do not use the vacuum to pick up flammable or combustible liquids such as gasoline, or use it in areas where they may be present.

You can turn the LG V-WP168NT on or off by pressing the power switch located on the top of the handle.

To clean dust on the floor with your LG V-WP168NT, please use the floor nozzle as follows:

1. Insert the telescopic pipe into the handgrip reelingly.

2. Insert the floor nozzle into the telescopic pipe reelingly.

3. Put the hose joint into the socket on the main unit.

4. When you want to take the hose out, press the button and pull the hose joint out.

You can use the LG V-WP168NT vacuum cleaner as a blower for cleaning places where the cleaning head cannot reach. Follow these steps:

1. Put the hose joint into the blowing hole until it is fastened.

2. To take the hose out, pull the hose joint out.

When the red drogue appears in the indicator window continuously, it means the dust room could be full or the airway could be blocked. You should deal with this situation immediately. Continuing to operate the vacuum cleaner when the red drogue appears continuously may cause the motor to burn out.

If you hear a whistle or scream, it means the safety-air-inlet-valve is operating. This indicates that the dust room may be full or the airway may be blocked. You should check for blockages or empty the dust room immediately.

To use the attachments for your LG V-WP168NT:

Dust brush: This tool is for cleaning small areas such as chairs, sofas, curtains, or describing surfaces. Insert it into the handgrip reelingly.

Crevice tool: This tool is used for cleaning gaps, corners, etc. To use it, insert it into the handgrip.

You can adjust the suction power on your LG V-WP168NT by slipping the adjusting button on the handle. The bigger the air hole is, the lower the suction power. It is suggested that you use lower suction power when cleaning curtains, jalousies, or other delicate cloths.

The back of the dolly on the LG V-WP168NT has a storage space for the dusting brush and crevice nozzle. You can place the attachments on this storage space for handy retrieval.

When dust accumulation in your LG V-WP168NT is excessive, please remove the dust by following these steps:

1. Turn off the machine and pull out the plug from the wall outlet.

2. Remove the hose, and release the clamps by pulling the lower side of them on each side, then take off the upper case.

3. Take the upper case and shake the cloth filter about 20 times to remove the clogging dust from the filter. If fluff remains excessively on the filter, remove it with a brush. Do not shake the filter up and down.

4. Take off the filter and dispose of the dust in the tank.

5. Place the filter back into the tank, and set the upper case on the tank.

To store the power cord for your LG V-WP168NT, wind the power cord and hang it on the hanger located on the side of the unit.

For neat and tidy storage of your LG V-WP168NT, the hose, telescopic pipe, and floor nozzle can be stored in an assembled condition to the cleaner. Coil the hose around the telescopic pipe to make it compact and stable, and then rest the telescopic pipe on the pipe rest on the unit.

To ensure good suction power, please clean the filter at least twice a year after disposing of the dust. Follow these steps:

1. Switch the appliance OFF and pull out the plug from the socket before replacing the filter.

2. Take the filter ring out of the filter.

3. Wash the filter in tepid water or a neutral detergent. If detergent is used, rinse it out thoroughly.

4. Allow the filter to dry naturally.

Caution:

• Avoid washing the filter in boiling water or by washing machine.

• Avoid drying over a fire or in hot sun.

• If the filter is used when wet, suction is impaired and the motor may be damaged.

If your LG V-WP168NT won’t run, check the following possible causes and solutions:

If the suction on your LG V-WP168NT is low, check the following possible causes and solutions:

If your LG V-WP168NT picks up movable rugs or the nozzle is too hard to push, follow this solution:

The specifications for the LG V-WP168NT are as follows:

ATTACHMENTS

These specifications are subject to change according to the agent/buyer’s request.