LG LB651078 (01) PDF Document

For your safety when installing the LG LB651078 oven, please adhere to the following precautions:

1. Any electrical installation work must be carried out by a qualified electrician or competent person.

2. The appliance must be installed according to the provided instructions to avoid damage.

3. The oven should be disconnected from the power supply before any installation or maintenance is performed.

4. The oven must always be earthed.

To install the LG LB651078 oven into a low kitchen cabinet, please follow these steps:

1. Ensure the kitchen cabinet dimensions meet the requirements. The minimum width should be 560 mm, the minimum depth 556 mm, and the minimum height 600 mm.

2. The oven power supply must be located in the back area (P) of the kitchen cabinet or outside the installation space.

3. Depending on the position of your power supply, make a hole “P” in the back wall or a hole “R” in the side wall of the kitchen cupboard to pass the connection lead through.

4. Lift the oven using the side holes and slide it into the cabinet. Do not attempt to lift the oven by the door handle on the front.

5. Take care not to kink the wires of the electrical supply cable during installation.

6. If you are also installing a hob, follow the hob installation instructions.

When installing the LG LB651078 oven in a high cabinet, please follow these guidelines:

1. Ensure the cabinet dimensions are appropriate. The minimum width should be 560 mm and the depth should be a minimum of 556 mm. The height for the oven space should be 590 mm (with a tolerance of min. 575 mm to max. 596 mm).

2. A minimum gap of 10mm must be maintained between the rear of the installed oven and the connecting wall.

3. To lift the oven, use the side holes provided.

4. The kitchen cabinet material in contact with the oven must be heat resistant up to 90°C.

5. Any close unit fronts must be heat resistant up to at least 70°C.

For correct ventilation of your LG LB651078 oven, the following is required:

1. A ventilation opening of 50mm should be present between the back wall and the floor of the installation cabinet.

2. A ventilation gap of 5mm is required between the oven’s top rim and the cooktop’s lower rim.

3. A ventilation gap of 5mm is required between both side rims of the oven and the cabinet.

These openings must not be closed in any way. Ensure that the sides of the oven are not touching the front edges of the housing.

The LG LB651078 oven must be connected to the power supply by a licensed specialist in accordance with these instructions and local regulations. Follow these electrical connection requirements:

1. Make sure the voltage shown on the rating plate is the same as the power supply voltage in your home. The oven’s components operate at 220-240V.

2. Use a type H05 VV-F power cord.

3. The oven must be connected to the power supply by means of an all-pole disconnect switch with a minimum contact gap of 3mm.

4. It must be connected to an earthed socket by law.

5. The supply plug must be accessible after the installation is complete.

6. Correctly identify the phase (Live) and neutral conductor in the socket to prevent damage to the oven. Incorrect connection may damage the oven.

After sliding the LG LB651078 oven into the cabinet and connecting it to the power supply, you must secure the oven to the kitchen unit using screws.