LG 32LB620V-ZA (01) PDF Document

To attach the stand to your LG 32LB620V-ZA, follow these steps:

1. Place the screen facing down on a cushioned table or flat surface to protect the screen from scratches.

2. Assemble the stand parts. For your model (LB62**-ZA/ZB), you will attach the “A Stand Base” to the “B Stand Base”.

3. Attach the assembled stand to the TV set.

4. Secure the stand to the TV using the provided screws. For the 32LB62**-ZA/ZB model, you will use 4 screws of size M4 x L20.

Connect your LG 32LB620V-ZA to a wall antenna socket using an RF cable (75 Ω).

NOTE:

• Use a signal splitter if you need to connect more than 2 TVs.

• If the image quality is poor, install a signal amplifier to improve it.

• If image quality is poor with an antenna connected, try to realign the antenna in the correct direction.

• An antenna cable and converter are not supplied.

• Supported DTV Audio includes MPEG, Dolby Digital, Dolby Digital Plus, and HE-AAC.

To connect a satellite dish to your LG 32LB620V-ZA, which is a satellite model, connect the TV to a satellite dish to a satellite socket with a satellite RF cable (75 Ω). The input is labeled LNB Satellite IN.

The Euro Scart connection transmits video and audio signals from an external device to your TV. Connect the external device and the TV set with a Euro Scart cable. Ensure any Euro Scart cable used is signal shielded.

The AV1 (TV Out) port functions as follows based on the current input mode:

Note: When watching digital TV in 3D imaging mode on your LG 32LB620V-ZA (a 3D model), only 2D out signals can be output through the SCART cable.

You can connect various external devices such as HD receivers, DVD players, VCRs, audio systems, USB storage devices, PCs, and gaming devices to your TV.

• The external device connection may differ from the model.

• Connect external devices to the TV regardless of the order of the TV port.

• If you record a TV programme on a DVD recorder or VCR, ensure the TV signal input cable is connected to the TV through the recorder or VCR.

• Refer to the external equipment’s manual for operating instructions.

• If you connect a gaming device, use the cable supplied with it.

• In PC mode, noise may be associated with resolution, vertical pattern, contrast, or brightness. If noise is present, change the PC output to another resolution, change the refresh rate, or adjust the brightness and contrast on the PICTURE menu until the picture is clear.

• In PC mode, some resolution settings may not work properly depending on the graphics card.

Please observe the following safety instructions when using your LG 32LB620V-ZA:

• Do not place the TV or remote in environments exposed to direct sunlight, high humidity, heat sources, steam, oil, rain, or wind.

• Do not place the product where it might be exposed to dust.

• Do not touch the power plug with wet hands. Dry the cord pin if it is wet or dusty.

• Ensure the power cord does not contact hot objects like a heater.

• Do not place heavy objects on power cables.

• Bend the antenna cable between the inside and outside of the building to prevent rain from flowing in.

• Do not plug too many electrical devices into a single multiple electrical outlet.

• Do not drop the product or let it fall over when connecting external devices.

• Keep packing materials out of the reach of children.

• Do not let children climb or cling onto the TV.

• Dispose of used batteries carefully.

• Do not put or store inflammable substances near the product.

• Do not drop metallic or inflammable objects into the product.

• Do not spray water on the product or scrub with an inflammable substance.

• Never touch the product or antenna during a thunder or lightning storm.

• Do not disassemble, repair, or modify the product at your own discretion.

• Unplug the TV if you do not intend to use it for a long period.

• Do not install the product on a wall if it could be exposed to oil or oil mist.

Viewing Environment and Time:

• When watching 3D content, take a 5 to 15-minute break every hour. Viewing for a long period may cause headaches, dizziness, fatigue, or eye strain.

• Maintain a distance of at least twice the screen diagonal length when watching 3D content. If you feel discomfort, move further away from the TV.

Photosensitive Seizure or Chronic Illness:

• Some users may experience a seizure when exposed to flashing lights or particular patterns from 3D content.

• Do not watch 3D videos if you feel nausea, are pregnant, or have a chronic illness such as epilepsy, cardiac disorder, or blood pressure disease.

• 3D content is not recommended for those who suffer from stereo blindness or stereo anomaly.

• If you have strabismus, amblyopia, or astigmatism, you may feel fatigue easily. It is advised to take more frequent breaks.

Viewing Age:

• Usage/Viewing of 3D content for children under the age of 6 is prohibited.

• Children under 10 may overreact; special monitoring and extra attention are required.

• Teenagers under 19 may react with sensitivity. Advise them to refrain from watching for a long time when tired.

• The elderly may perceive less 3D effect. Do not sit closer than the recommended distance.

Cautions when using 3D glasses:

• Make sure to use LG 3D glasses.

• Do not use 3D glasses instead of normal glasses, sunglasses, or protective goggles.

• Do not keep your 3D glasses in extremely high or low temperatures, as it will cause deformation.

• The 3D glasses are fragile and easily scratched. Always use a soft, clean cloth when wiping the lenses.

The Joystick button is located below the TV screen and allows you to operate basic functions:

• Power On: When the TV is off, place your finger on the joystick button and press it once and release it.

• Power Off: When the TV is on, press and hold the joystick button for a few seconds and release it.

• Volume Control: Place your finger over the joystick button and move it left or right to adjust the volume.

• Programmes Control: Place your finger over the joystick button and move it up or down to scroll through saved programmes.

When the TV is turned on, press the joystick button one time. You can then move the joystick up, down, left, or right to adjust the following menu items:

• Turns the power off.

• Settings: Accesses the main menu.

• Close: Clears on-screen displays and returns to TV viewing.

• Input List: Changes the input source.

To prevent scratches or damage, please follow this advice:

• Avoid touching the screen at all times.

• It is recommended to move the TV in its original box or packing material.

• Before moving or lifting, disconnect the power cord and all cables.

• When holding the TV, the screen should face away from you to avoid damage.

• Hold the top and bottom of the TV frame firmly. Do not hold the transparent part, speaker, or speaker grill area.

• When transporting a large TV, there should be at least 2 people.

• Keep the TV upright during transport; never turn it on its side or tilt it.

• Do not apply excessive pressure to the frame chassis as it may damage the screen.

1. Lift and tilt the TV into its upright position on a table.

2. Leave a 10 cm (minimum) space from the wall for proper ventilation.

3. Connect the power cord to a wall outlet.

CAUTION: Do not place the TV near or on sources of heat, as this may result in fire or other damage.

1. Insert and tighten the eye-bolts, or TV brackets and bolts, on the back of the TV. If there are bolts already in the eye-bolt positions, remove them first.

2. Mount the wall brackets with bolts to the wall. Match the location of the wall bracket and the eye-bolts on the rear of the TV.

3. Connect the eye-bolts and wall brackets tightly with a sturdy rope. Make sure to keep the rope horizontal with the flat surface.

CAUTION: Make sure that children do not climb on or hang on the TV.

NOTE: Use a platform or cabinet that is strong and large enough to support the TV securely. Brackets, bolts, and ropes are not provided. You can obtain additional accessories from your local dealer.

To mount your LG 32LB620V-ZA on a wall, use a wall mount bracket that meets the VESA standard. LG recommends that wall mounting be performed by a qualified professional installer.

For the 32LB62** model:

• VESA (A x B): 200 x 200 mm
• Standard screw: M6
• Number of screws: 4
• Wall mount bracket models: LSW240B, MSW240

CAUTION:

• Disconnect the power first, then move or install the TV.

• Use an authorized LG wall mount. Do not over-tighten the screws.

• Use screws and wall mounts that meet the VESA standard. Damages or injuries by misuse or using an improper accessory are not covered by the warranty.

The remote control for your LG 32LB620V-ZA has the following functions:

You can adjust the picture settings on your LG 32LB620V-ZA through the SETTINGS menu.

• Picture Wizard III: Calibrates and adjusts for optimum picture quality using the remote control without expensive pattern devices.

• Picture Mode: Select a picture mode optimized for your viewing environment.

– Vivid: Heightens contrast, brightness, and sharpness.

– Standard: Displays images in standard levels.

– Eco/APS: Reduces power consumption.

– Cinema/Game: Displays the optimum picture for movies or games.

– Sports: Optimizes for high and dynamic actions.

– Expert 1, 2: Menu for advanced picture quality adjustment for ISF-certified professionals.

• Advanced Control / Expert Control: Calibrates the screen for each picture mode with options like Dynamic Contrast, Dynamic Colour, Skin Colour, Gamma, Colour Gamut, Edge Enhancer, etc.

You can manage audio output through the SETTINGS → AUDIO menu:

• TV Speaker: Sound is output through the TV’s internal speakers.

• External Speaker (Optical): Sound is output through a speaker connected to the optical port. SimpLink is supported.

• LG Sound Sync (Optical): Connect an LG audio device for rich, powerful sound.

• Headphone: Sound is output through the headphone port.

• AV Sync. Adjust: Synchronizes video and audio if they do not match. If set to ON, you can adjust the sound output to the screen image.

You can also set the Digital Sound Out format when using an external speaker:

To remove a USB device:

Go to Q.MENU → USB Device. Select the USB storage device you want to remove. When you see the message that the device has been removed, you can safely separate it from the TV.

Warnings for using a USB device:

• Use only USB storage devices formatted with the Windows FAT32 or NTFS File System.

• For external USB HDDs, it is recommended to use devices with a rated voltage of less than 5 V and a rated current of less than 500 mA.

• It is recommended to use USB memory sticks of 32 GB or less and USB HDDs of 1 TB or less.

• If a USB HDD with a power-saving function does not work properly, turn the power off and on.

• Data on the USB storage device can be damaged, so be sure to back up important files. Data maintenance is the user’s responsibility.

Supported Video Formats:

• Maximum: 1920 x 1080 @ 30p (only Motion JPEG 640 x 480 @ 30p)

• Formats: .asf, .wmv, .divx, .avi, .ts, .trp, .tp, .mts, .m2ts, .vob, .mp4, .m4v, .mov, .mkv, motion JPEG, .mpg, .mpeg, .mpe, .dat, .flv, .3gp, .3gp2.

Supported Audio Formats:

• File types: .mp3, AAC, M4A, WMA, OGG.

Supported Photo Formats:

• Category: 2D (jpeg, jpg, jpe), BMP, PNG.

• BMP and PNG format files may be slower to display than JPEG.

Supported Subtitle Formats:

• External: *.srt, *.smi, *.sub, *.ass/*.ssa, *.txt, *.psb.

• Internal: XSUB (Supports internal subtitles generated from DivX6).

Clean your TV regularly to maintain the best performance and extend its lifespan. First, make sure to turn the power off and disconnect all cables.

Screen, frame, cabinet and stand:

• To remove dust or light dirt, wipe the surface with a dry, clean, and soft cloth.

• To remove major dirt, wipe the surface with a soft cloth dampened in clean water or a diluted mild detergent. Then wipe immediately with a dry cloth.

CAUTION:

• Avoid touching the screen at all times.

• Do not push, rub, or hit the screen surface with your fingernail or a sharp object.

• Do not use any chemicals as this may damage the product.

• Do not spray liquid onto the surface.

Power cord:

• Remove the accumulated dust or dirt on the power cord regularly.

• Check the remote control sensor on the product and try again.

• Check if there is any obstacle between the product and the remote control.

• Check if the batteries are still working and properly installed.

• Check if the product is turned on.

• Check if the power cord is connected to a wall outlet.

• Check if there is a problem in the wall outlet by connecting other products.

• Check the power control settings. The power supply may be interrupted.

• Check if the Automatic Standby, Sleep Timer, or Off Time feature is activated in the TIME settings.

• If there is no signal while the TV is on, it will turn off automatically after 15 minutes of inactivity.

• Turn the TV off/on using the remote control.

• Reconnect the HDMI cable.

• Restart the PC with the TV on.