LAZER LIFEBEAM (01) PDF MANUAL


Post questions, comments, reviews or errors in the comment box below.

Your File is Ready … Download PDF

CLICK HERE TO DOWNLOAD LAZER LIFEBEAM (01) PDF MANUAL


PDF Content Summary: LifeBEAM Gear / installation manual A/ Installation of the headband C/ Installation of the device Turn the helmet over and remove the front foam pad. Install the LifeBEAM Z1 Blade sensor pad in place of the foam pad. Depending upon the size of the helmet you may consider trimming the Life- BEAM sensor pad at the ends. Look for the trim line on each end of the pad and use standard scissors to cut the pad. Lay the sensor wire along the inside surface of helmet. You may consider using a small strip of tape to secure the wire in place. When the wire reaches the back of the helmet thread the wire through the vent on the right side of the LifeBEAM MudCap. The sensor wire is now ready to be plugged into the transmitter. B/ How to attach the device onto the helmet? Wasp Air Revolution To attach the LifeBEAM transmitter to the helmet use the rubber slots on the transmit- ter case and hook the transmitter onto the LifeBEAM MudCap. Assure the transmitter is attached securely. Then plug in the sensor wire. Z1 Blade Wasp Air, Revolution Lamorinièrestraat 33-37 - 2018 Antwerp - Belgium lazersport.com


FREE ENGLISH PDF

OPERATING INSTRUCTIONS

USER GUIDE - USER MANUAL

OWNER GUIDE - OWNER MANUAL

REFERENCE GUIDE - REFERENCE MANUAL

INSTRUCTION GUIDE - INSTRUCTION MANUAL

Leave a Reply