Post questions, comments, reviews or page errors in the comment box below.
PDF Content Summary:
****** Page 1 ****** 1M 091-31-12-115/230 Revision A, 12-09-04 INSTRUCTION MANUAL- CHARGE MODEL-CS): 091-31-12-115 091-31-1 e-æao OUTPUT: 13.es VOLTS DC, 1 AMPERE. INPUT: ISVAC, 50/60Hz eaovAc, so/B0HZ a YEAR WARRANTY KUSSMAUL ELECTRONICS CO., INC. 1 70 CHERRY AVE. , WEST SAYVILLE, N.Y. 1 1 TEL: in NY 631-567-0314 TOLL FREE: 800-346-0857 FAX: 631-567-5826
****** Page 2 ****** INTRODUCTION The Model 091-31-12-115/230 automatic battery charger is a completely automatic battery charger designed to charge small lead-acid batteries at a rate of 1 ampere or less. The unit is current limited to 1 ampere and provides a low ripple charging current. The charger will charge the batteries whenever theirfloat voltage drops. When the batteries are fully charged, all charging stops. Any load applied to the battery when the charger is connected and energized will automatically be supplied by the charger up to the maximum 1 ampere capacity. The Model 091-31-12-115/230 is factory set for 1 15VAC or 230VAC primary power operation at time of order. Please verify that installation primary power and 091-31-12-115/230 input power requirements are correct prior to installation and operation. SPECIFICATIONS: Input: 115VAC or 230VAC +1- 10 volts, 50/60 Hertz. Factory Set Output: DC, 13.25 Volts, Ripple: less than 100 mv Current: 0 to 1 amp depending on battery state of charge Input Wiring: #18 AWG: Blue and Brown, Refer to Figure 1. Output Wiring: Via Pl/J1: Refer to Figure 1 Power Indicator: none Weight: 19 ounces
****** Page 3 ****** FIGURE 1 INSTALLATION and WIRING 550 500 Ø.187 (4) 175 ooo 00000 ooo ooo ooo ooo ooo ooo ooo ooo ooo 12 ooo 325 VDC OUT 2.75 JI/PI, 12VDC OUT PIN RE URN, GROUND PIN +12VDC 115VAC/230VAC 50/60Hz INPUT 115/ El..iæ 115/ a-locsqALNl-nqæRTÆFQVElNAJTE”11NG INSTAL.AIIO+I.
****** Page 4 ****** INSTALLATION Date Installed Installed By Vehicle Identification Vehicle Owner RECORD e WARRANTY WARRANTY All products of Kussmaul Electronics Company Inc. are warranted to be free of defects of material or workmanship. Liability is limited to repair- ing or replacing at our factory, without charge, any material or defects which become apparent in normal use within 3 years from the date the equipment was shipped. Kussmaul Electronics Company, Inc. shall have no liability for dam- ages of any kind to associated equipment arising from the installation and /or use of the Kussmaul Electronics Company, Inc. products. The pur- chaser, by the acceptance of the equipment, assumes all liability for any damages which may result from its installation, use or misuse, by the purchaser, his or its employees others.
FREE ENGLISH PDF
USER GUIDE – USER MANUAL
OWNER GUIDE – OWNER MANUAL
REFERENCE GUIDE – REFERENCE MANUAL
INSTRUCTION GUIDE – INSTRUCTION MANUAL