Post questions, comments, reviews or page errors in the comment box below.
PDF Content Summary:
****** Page 1 ****** INDICATOR SEAL INSTALLATION (091-39-109) Locate Indicator in a convenient place on the vehicle. 1 2. Place the template in position and center punch in 8 places. 3. Drill holes as shown. 4. Cut out opening connecting 1/2″ holes together. 5. Strip jacket 3″ from cable and insert cable thru seal so jacket penetrates past grommet seal. 6. Connect wiring to indicator connector in accordance with indicator installation procedure. 7. Install as shown. 8. Insert (4) #8 screws and tighten, (CAUTION: Do not over tighten because you will bend the plastic bezel and break the watertight seal). #8 SCREW INDICATOR SEAL 3/16″ DIA 4 PLACES 2.375 1.850 NUT LOCK WASHER ASSEMBLY 3.900 3.250 1/2″ DIA 4 PLACES Cut, 4 places HOLE TEMPLATE KUSSMAUL ELECTRONICS CO., INC- 170 CHERRY AVE. , WEST SAYVILLE, N.Y. 11796 TEL: in NY 631-567-0314 TOLL FREE: 800-346-0857 FAX: 631-567-5826
FREE ENGLISH PDF
USER GUIDE – USER MANUAL
OWNER GUIDE – OWNER MANUAL
REFERENCE GUIDE – REFERENCE MANUAL
INSTRUCTION GUIDE – INSTRUCTION MANUAL