KUSSMAUL 091-148-12 (01) PDF MANUAL


Post questions, comments, reviews or page errors in the comment box below.

Click here to download KUSSMAUL 091-148-12 (01) PDF MANUAL


PDF Content Summary:

****** Page 1 ****** SAFETY AUTOMATIC SAFETY LOCK A CONTROLLER WHICH PERMITS UNATTENDED ENGINE OPERATION BUT PREVENTS UNAUTHORIZED USE OF THE UEHICLE SIMPLE INSTALLATION PERMITS ENGINE TO RUN WITH THE IGNITION KEY REMOVED ENGINE STOPS AND CANNOT BE RESTARTED IF ATTEMPT IS MADE TO DRIVE AWAY This simple, low cost controller bypasses the ignition switch when activated by the closure of a momentary switch. The operator may then remove the ignition key without shutting the engine down. Movement of the ve- hicle is prohibited by interlocking fre SAFETY LOCK Wth a switch operated by the foot &ake, a neutral safety switch on the gearshift ora parking brake operated switch. ating any one ofthese will cause fre relays in fre SAFETY LOCK to drop out and interrupt the ignition circuit to stop the engine. The authorized operator need only insert the key and turn on the ignition to operate the vehicle. With the key in the lock and turned on, the ignition circuit is completed as normal and the opening of the SAFETY LOCK relays has no effect on engine operation. This unit is for vehicles that require 3 independent relays for the vehicles ignition. SPECIFICATIONS: Volts: 12 volts, D.C. Relay Contacts: Normally Open, 30 Amps. SAÉE-ry MODEL #091-148-12 3/16″ DIA. 2.625 o 4.00 O OUTLINE Weight: 4 ounces Enclosure:unsealed 170 Cherry Avenue West Sayville, NY 11796 kussmaul.com File: 1M 091-1 48-12 Revised By: Date: 01-20-2002 KUSSMAUL ELECTRONICS ENERGIZED AND READY, WHEN SECONDS COUNT DRAWING Ph: 800-346-0857 Fax: 631-567-5826 sales@kussmaul.com

****** Page 2 ****** +12 volt The common terminal of the relay must be connected to the +12 volt power for the unit to operate Brake Light Switch IGNITION SWITCH N.C.= To Ignition System O O N.O. COM. O SET PUSHBUTTON Sl 1 2 3 4 O 5 This line resets Brake Light INSTALLATION: This line sets (bypasses ignition) Indicator illuminates when ignition switch is bypassed (OPTIONAL) 1 . Mount unit in a suitable location protected from moisture and excessive heat. 2. Wire in accordance with the wiring diagram above OPERATION: 1. With the engine running depress the momentary SET switch Sl. The relay will close, the LED will be illuminated and the engine will continue to run when the key is removed. 2. Remove the key from the ignition. The LED will continue to be illuminated and the engine will continue to run. 3. Step on the foot brake. The LED will go out and the engine will stop. 4. Start the engine and repeat step 1. 5. Insert the key, turn ignition switch to ON and verify that the ergine continues to run when the brake pedal is depressed. MODEL 091-148-12 SAFETY LOCK A Controller To Permit Engine Operation With The Ignition Switch Removed INSTALLATION AND WIRING INSTRUCTIONS


FREE ENGLISH PDF

OPERATING INSTRUCTIONS

USER GUIDE – USER MANUAL

OWNER GUIDE – OWNER MANUAL

REFERENCE GUIDE – REFERENCE MANUAL

INSTRUCTION GUIDE – INSTRUCTION MANUAL

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.