KRK KDV 96 (01) PDF MANUAL

These models measure the voltage value of any line (AC+DC) very accurately in true RMS. Any line can be measured between 0…500V.

These models measure the true RMS voltage value of the line very accurately.

The measured values for the lines are shown every 3 seconds in a cycle.

If the user would like to observe the value of any specific line, the user needs to select the desired value. The selected value will be shown continuously for 60 seconds, after which the device will begin cycling through the line values again.

Code	Display	Measurement Range	Dim.	Weight (kg)
KDV 72	3 Digit, Red, 14mm	0..500V	Figure-1	0,20
KDV 96	3 Digit, Red, 14mm	0…500V	Figure-2	0,24
KDV 72-3F	3 Digit, Red, 14mm	L1: 180V…260V L2: 5…300V L3: 5…300V	Figure-1	0,20
KDV 96-3F	3 Digit, Red, 14mm	L1: 180V…260V L2: 5…300V L3: 5…300V	Figure-2	0,24
KDV 35	3 Digit, Red, 10mm	0…500V	Figure-3	0,19
KDV 35-3F	3 Digit, Red, 10mm	L1: 180V…260V L2: 5…300V L3: 5…300V	Figure-3	0,19

Accuracy: ± (%1+1)

Class: 0,5

Supply Voltage: 220 Vac ±%20, 50 / 60 Hz

Power Consumption: < 3 VA

Ambient Temperature: -5°C…+ 55°C

These models have four terminals. Two terminals are for the Measurement Input, and the other two are for the Supply Input. Refer to the Connection Schemes diagram for KDV 72 / KDV 96 for specific terminal locations.

These models have four terminals labeled L3, L2, L1, and N. These terminals are used for both supply and measurement input. Refer to the Connection Schemes diagram for KDV 72-3F / KDV 96-3F for specific terminal connections.

The KDV 35 model has four terminals. Two terminals are labeled L and N for Measurement Input, and the other two are labeled L and N for Supply Input. Refer to the Connection Schemes diagram for KDV 35 for specific terminal locations.

The KDV 35-3F model has four terminals labeled L3, L2, L1, and N. These terminals are used for both Supply and Measurement Input. Refer to the Connection Schemes diagram for KDV 35-3F for specific terminal connections.

Figure-1 (applies to KDV 72 and KDV 72-3F):

Front Bezel: 72 mm (W) x 72 mm (H)

Panel Cutout: 65 mm x 65 mm

Depth behind panel: 73 mm

Figure-2 (applies to KDV 96 and KDV 96-3F):

Front Bezel: 96 mm (W) x 96 mm (H)

Panel Cutout: 90 mm x 90 mm

Depth behind panel: 64 mm

Figure-3 (applies to KDV 35 and KDV 35-3F):

Front Bezel Width (approx): 45 mm (based on terminal block width)

Overall Height: 65 mm

Panel Cutout Height: 50 mm (inner dimension)

DIN Rail Mount Width: 35 mm

Overall Depth: 58 mm

Depth from front face to mounting clip surface: 35.3 mm

Height from DIN rail bottom edge to top: 65 mm

Panel Cutout Width: 34 mm (inner dimension)