Free English KIDDE 10SDR-CA (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.


CLICK HERE TO DOWNLOAD KIDDE 10SDR-CA (01) PDF DOCUMENT

If this is not the document you want for this product, click here to see if we have any other documents for this product.


How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.


What is the alarm pattern for the KIDDE 10SDR-CA Smoke Alarm when it sounds?

The smoke alarm pattern for the KIDDE 10SDR-CA is three long beeps, a 1.5 second pause, and three long beeps repeating. The red LED blinks in time with the alarm pattern.


What should I do immediately when the KIDDE 10SDR-CA Smoke Alarm sounds?

Alert small children in the home as well as anyone else that might have difficulty recognizing the importance of the alarm sounding or that might have difficulty leaving the area without help.

Plan two ways out! Leave immediately by your escape plan. Don’t waste time getting dressed or picking up valuables.

While leaving, don’t open any inside door without first feeling its surface. If hot, or if you see smoke seeping through cracks, don’t open that door! Instead, use your alternate exit. If the inside of the door is cool, place your shoulder against it, open it slightly and be ready to slam it shut if heat and smoke rush in.

If the escape route requires you to go through smoke, stay close to the floor where the air is cleaner. Crawl if necessary, and breathe shallowly through a cloth, wet if possible.

Once outside, go to your selected meeting place and make sure everyone is there.

Call the fire department or 911 from your cell phone outside, or from your neighbour’s home-not from yours!

Don’t return to your home until the fire officials say that it is all right to do so.


What is the normal standby visual indication for the KIDDE 10SDR-CA Smoke Alarm?

The Red LED blinks approximately every 60 seconds for normal (standby) operational mode for the KIDDE 10SDR-CA Smoke Alarm.


What is the audible indication when performing a test on the KIDDE 10SDR-CA Smoke Alarm when no alarm condition is present?

When testing the KIDDE 10SDR-CA Smoke Alarm when no alarm condition is present, the audible indications are a single beep, 3 long beeps followed by a pause, then 3 long beeps, and another single beep.


What action should be taken when the KIDDE 10SDR-CA Smoke Alarm is in Smoke Alarm Memory mode?

Alarm memory is only retained for 24 hours on the KIDDE 10SDR-CA Smoke Alarm. Push the test button to clear Alarm Memory.


How is the Smoke Alarm Hush Mode activated and deactivated on the KIDDE 10SDR-CA Smoke Alarm?

The Hush™™ feature on the KIDDE 10SDR-CA Smoke Alarm is to be used only when a known alarm condition, such as smoke from cooking, activates the alarm. Push the button again to cancel Hush™™.


What are the visual and audible indicators for a Low Battery trouble condition on the KIDDE 10SDR-CA Smoke Alarm?

For a Low Battery trouble condition on the KIDDE 10SDR-CA Smoke Alarm, the Visual Indication is the Red LED blinks every 60 seconds, and the Audible Indication is a Chirp every 60 seconds.