JURA ENA 5 (01) PDF Document

Keep children under the age of 8 away from the JURA ENA 5 or supervise them constantly. Children aged 8 and over may only operate the JURA ENA 5 without supervision if they have been instructed in how to use it safely. Children may not clean or service the JURA ENA 5 unless supervised by a responsible person. Do not allow children to play with the JURA ENA 5.

Never use a damaged JURA ENA 5 or mains cable, as this could result in a fatal electric shock. In the event of signs of damage, disconnect the JURA ENA 5 from the mains. To do this, first switch the JURA ENA 5 off with the On/Off button. Only then should you remove the mains plug from the power socket.

Do not place the JURA ENA 5 in a cabinet when in use. Keep it away from hot surfaces and avoid letting the mains cable rub against sharp edges or hang loosely. Protect the JURA ENA 5 from weather and direct sunlight. Only connect the JURA ENA 5 to a mains voltage matching the rating plate located on the underside. Do not use multi socket adapters or extension cords. Only use mild cleaning agents, avoid alcohol or alkaline based agents, and never use coffee beans treated with additives.

Never touch the mains plug with wet hands and do not immerse the JURA ENA 5 or its mains cable in water. Do not put the JURA ENA 5 or any parts in the dishwasher. Before cleaning, switch the JURA ENA 5 off with the On/Off button. Always wipe the JURA ENA 5 with a damp cloth rather than a wet one, and do not clean it with a jet of water.

Remove the aroma preservation cover, fill the bean container with roasted, untreated coffee beans, and close the cover. Do not use beans treated with additives, ground coffee, or freeze dried coffee as these will damage the grinder.

Hold the provided Aquadur test strip under running water for one second, shake off the excess water, and wait about one minute. You can then read the degree of water hardness from the discolouration of the test strip and the packaging description.

After ensuring the bean container is filled, insert the mains plug into a power socket and press the On/Off button to switch on the JURA ENA 5. Select your preferred language, touch Save, set the water hardness using the arrows, and touch Save. Place a receptacle under the coffee spout, insert the filter cartridge into the water tank, and fill it with fresh, cold water. The JURA ENA 5 will automatically detect the filter, rinse it, and indicate when it is ready for use.

The JURA ENA 5 offers three indulgence worlds. Classic Hot Brew uses the classic hot brewing process. Cold Brew uses the Cold Extraction Process with cold water pulsed at high pressure. Light Brew uses less ground coffee and a reduced brewing temperature for easier digestion.

Place a cup under the coffee spout and tap the Coffee button. To ensure the best taste, pre heat the cup.

Fill the water tank with fresh, cold water, add ice cubes to a glass, and place the glass under the coffee spout. Use the arrows to navigate to the third page of the start screen to access the Cold Brew indulgence world, then tap the Coffee button.

Tap the JURA Cockpit, enter the Machine settings, select Ground coffee mode, tap Active, and save. Tap the Espresso button on the start screen. When prompted, open the powder chute, fit the filler funnel, add one level measuring spoon of ground coffee into the funnel, remove the funnel, close the chute, and touch Next.

Only adjust the grinder while it is running. Place a cup under the coffee spout, tap a product like Espresso to start preparation, and turn the grinding wheel to the desired position while the grinder is operating.

Touch and hold a product on the start screen for approximately 2 seconds to access Product settings. From there, you can change the coffee strength or quantity. Some products allow temperature changes. Tap Save when finished.

Daily tasks include emptying the drip tray and coffee grounds container, rinsing with warm water, and rinsing the water tank. Always empty the coffee grounds container while the JURA ENA 5 is switched on to reset the counter. Wipe the surface with a clean, soft, damp cloth.

Place a receptacle under the coffee spout and press the On/Off button. The JURA ENA 5 will perform a rinsing process during this operation.

Remove the water tank, rinse it with fresh cold water, fill it with fresh cold water, and reinsert it into the JURA ENA 5.

When necessary, clean the inside of the water tank with a brush, clean the top and bottom of the cup grille, and thoroughly clean the drip tray and coffee grounds container.

In the Machine settings section, you can configure the Ground coffee mode, adjust the automatic Switch off after time, change the language, set the water hardness, adjust units, reset to Factory setting, modify Product name displays, initiate Empty system, view the Version, and manage Connections.

With the start screen displayed, place a receptacle under the coffee spout, tap the JURA Cockpit, touch the Maintenance symbol, and tap Rinse the coffee system to start the operation.

When prompted or when the filter symbol lights up red, remove and empty the water tank, remove the old filter cartridge, fit the filter cartridge extension onto a new filter, insert the new filter into the water tank, and fill it with fresh cold water. The JURA ENA 5 will detect the new filter and begin the rinsing process.

When prompted in the JURA Cockpit, fill the water tank, tap Clean, and touch Start. Empty the drip tray and coffee grounds container when prompted and place a receptacle under the spout. After water flows, open the powder chute, insert a JURA cleaning tablet, close the chute, and touch Next. Empty the drip tray and coffee grounds container again when finished.

When prompted in the JURA Cockpit, tap Descale and touch Start. Empty the drip tray and coffee grounds container. Remove and empty the water tank. Dissolve 3 JURA descaling tablets in 500 ml of water in a receptacle, pour the solution into the empty water tank, and insert it into the JURA ENA 5. Touch Next. When prompted, empty the drip tray and coffee grounds container, rinse the water tank, fill it with fresh water, and reinsert it. Place a receptacle under the spout and touch Next to finish the process.

When prompted, switch off the JURA ENA 5, remove the aroma preservation cover, and clean the container using a soft, dry cloth. Fill with fresh coffee beans and close the cover.

The water tank is empty. Fill the water tank with fresh, cold water.

The coffee grounds container or drip tray is full. Empty both components and reinsert them into the JURA ENA 5.

The drip tray is either not inserted at all or is not inserted correctly. Ensure it is properly fitted into the JURA ENA 5.

The bean container is empty. Fill it with fresh coffee beans.

There was insufficient ground coffee added to the machine for the selected operation. Add more ground coffee next time you prepare a beverage using the ground coffee mode.

The filter cartridge is exhausted. Replace the CLARIS Smart+ filter cartridge immediately.

The JURA ENA 5 requires a cleaning cycle. Perform the cleaning procedure as described in the maintenance section.

The JURA ENA 5 requires a descaling cycle. Perform the descaling procedure as described in the maintenance section.

The coffee might be ground too finely and obstructing the system. Adjust the grinder to a coarser setting or use coarser ground coffee. Alternatively, the water hardness may not have been set correctly; perform a descaling procedure.

The coffee beans currently in use are resulting in an above average volume of ground coffee. You can reduce the coffee strength or select a finer grinder setting to resolve this.

There is likely a significant amount of limescale in the water tank. Perform the Descaling the water tank procedure.

There are likely foreign objects in the grinder. Contact customer support for assistance.

The JURA ENA 5 may have been exposed to the cold for a long period, causing the heating to be disabled for safety reasons. Allow the JURA ENA 5 to warm up to room temperature.

With the start screen displayed, place a receptacle under the coffee spout, tap the JURA Cockpit, touch the Machine settings icon, navigate to the correct page, and tap Empty system. Remove and empty the water tank, and the JURA ENA 5 will finish the process and switch off.

Yes, the insert for the drip tray, the drip tray itself, and the coffee grounds container are dishwasher safe. However, always empty the coffee grounds container while the JURA ENA 5 is switched on to reset the counter.

Switch the JURA ENA 5 off using the On/Off button and contact customer support for further instructions.

During the grinding operation, tap the arrows on the screen to adjust the coffee strength.

During the brewing operation, tap the arrows on the screen to adjust the quantity.

Tap and hold a product on the start screen for approximately 2 seconds, then adjust the settings under Product settings. Temperature can also be changed for classic coffee and espresso products.

Tap the Cancel button on the display screen.

Tap and hold a product for around 2 seconds and select Reposition the product to change its location on the screen.

No, the JURA ENA 5 does not require descaling if you are using the CLARIS Smart+ filter cartridge.

Avoid contact with skin or eyes, as it can cause irritation. If it contacts the skin, rinse off with clean water. If it contacts the eyes, seek medical attention. Clean up any splashes on sensitive surfaces immediately.

The cleaning programme for the JURA ENA 5 lasts approximately 20 minutes.

The descaling programme for the JURA ENA 5 lasts approximately 20 minutes.

The JURA ENA 5 water tank has a capacity of approximately 1.1 litres.

The JURA ENA 5 bean container has a capacity of approximately 125 grams.

The JURA ENA 5 coffee grounds container holds approximately 10 servings.

The JURA ENA 5 has a static pump pressure of maximum 15 bar.

The JURA ENA 5 dimensions are 27.1 cm wide by 32.3 cm high by 44.5 cm deep. It weighs approximately 8.7 kilograms.