IVATION IVADM10 (01) PDF DOCUMENT

The IVATION IVADM10 device is intended for use in the removal of excess moisture from smaller rooms such as studies, walk-in closets and bathrooms. Other than the removable water tank, this device is not user serviceable and should not be disassembled. Any use other than that described will lead to damage to the product and may present additional risks.

The IVATION IVADM10 Dehumidifier works by way of thermoelectric cooling, which uses what’s known as the Peltier effect to create a heat flux between the junction of two different types of materials. Using no compressors or moving parts, the device pulls moisture from the air around it, removing muskiness and dampness from the room.

If damage is incurred as a result of non-compliance with these operating instructions, the manufacturer’s guarantee will be voided. Ivation™ assumes no liability for personal injury or damage to property caused by incorrect handling or non-observance of the safety instructions.

1. Keep unit in upright position whenever in use.

2. To avoid electric shock, avoid opening unit.

3. Always turn device off when not in use.

4. Avoid using power adapter in excessively wet area.

5. Ensure that inlet and outlet grilles are unobstructed.

6. Keep device away from reach of children.

– To remove excess moisture from small rooms, place the IVATION IVADM10 Dehumidifier in the preferred area.

– Insert smaller end of AC/DC Power Adapter (#11) into the DC Power Socket (#10).

– Connect the other end to a wall socket.

– Toggle the On/Off Switch (#3) to the On position.

– To turn the unit off at any time, toggle the On/Off Switch (#3) to the Off position first, then unplug the DC Power Adapter (#11).

The IVATION IVADM10 Dehumidifier will automatically turn off once the tank is full, and the Yellow “Full” LED (#2) will turn on.

– Before removing the water tank, toggle the On/Off Switch (#3) to the Off position.

– Insert two fingers into the Pull-Out Opening (#7) and gently pull out.

– Pull out the plug from the Water Displacement Hole (#8).

– Pour collected water out from the tank into a sink or toilet.

– Reinsert the plug and slide the tank back into the device until it clicks.

– The device is now ready for use again.

Always turn the IVATION IVADM10 Dehumidifier off and disconnect the power cord before cleaning the unit. Use a piece of soft cloth to clean the product surface, or use a soft-bristled brush to wipe dust off the air inlet grills.

Capacity: Approximately 8.45 Ounces/Day at 86°F, 80% RH

Water Tank Capacity: 16.9 Ounces

Cooling Element: Thermoelectric Peltier Module

Fan: 80mm x 80mm Brushless Motor

Power Adapter: 9v DC 2.5Amp

Power Consumption: 22.5w

Water Level Detector: Auto-Off When Full w/Yellow “Full” LED

Dimensions: 6.1″ x 8.66″ x 5.11″

1 x IVADM10 Dehumidifier

1 x Water Tank

1 x Power Cord

1 x User Manual

1. Green “On” LED

2. Yellow “Full” LED

3. On/Off Switch

4. Air Inlet Grill

5. Dry Air Outlet Grill

6. Removable Water Tank

7. Pull-Out Opening

8. Water Displacement Hole w/Plug

9. Hydraulic Cut-Off

10. DC Power Socket

11. AC/DC Power Adapter