IGET T1 (01) PDF Document

The IGET T1 has an increased resistance. However, it is not mechanically undestroyable.

The display is made of tempered glass, which ensures higher resistance against scratches. When dropped on a hard surface or sharp object, it may crack. The display cracked due to mechanical damage or improper misuse of the device is not covered by warranty.

The IGET T1 has the IP68 and IP69K certification under ISO 20653:2013 standard. The IP68 protection does not guarantee 100% resistance to water in all conditions (According to the manufacturer, up to 1.5 m to a depth of 30 minutes. The IP68 resistance does not apply to salt water or any other chemical additives, such as cleaning substances!).

We also recommend not to charge the phone and dry the phone’s connector after contact with water or other liquid with the adequately warm air flow (up to 40°C).

Outside the charging time, always keep the input for the charging connector and headphones properly closed with the cover.

The warranty is not applied to an intentional damage to the phone.

Warning: the microphone is located on the bottom of the phone, when overlapped (eg with your hand), the other side will not hear or will hear very poorly.

Switch your IGET T1 phone off before installing the card.

1. Carefully pull the SIM or microSD card holder from the side of the phone, insert the cards into the drawer, so they fit into the place and then put the drawer back into the phone.

2. You can use the 2x NANO SIM or 1x NANO SIM and 1x microSD card, according to diagram.

Before putting your IGET T1 phone into service you must recharge its battery for 100%.

1. Connect the adapter to the charger. USB-C can be rotated from both sides. Yet when attaching the connector, do not use violence.

2. Connect the charger to the wall outlet.

3. If the battery is fully charged, disconnect the phone from the charger.

Make sure that the IGET T1 phone has a SIM card and the battery is fully charged.

Press and hold the ON/OFF button to switch on the phone.

Switch off the phone by pressing and holding ON/OFF button and select OFF.

Press shortly ON/OFF button to switch the phone over to the sleep mode.

Do not use your IGET T1 phone while driving.

Do not use your phone at the petrol stations.

Hold the phone at least 15 mm from your ear and body.

The phone produces a bright or flashing light.

The small parts of the phone can cause suffocation.

Do not expose your phone to open fire.

The phone can produce a loud sound.

The phone is not resistant to fillings.

Avoid exposure to magnetic fields.

Keep the phone away from medical devices.

On request, turn off your phone in hospitals and other medical facilities.

Keep the phone dry.

On request, turn off the phone at airports and on planes.

Do not dismantle the phone.

Turn off the phone in the vicinity of explosive materials and chemicals.

Use the phone only with certified equipment.

Do not reckon only upon your phone during emergency situations.

The phone contains a label that detects moisture. In case of moisture inside phone this label becomes red. The manufacturer has the right to reject a warranty with such a damaged phone.

If such cases may occur, please, contact the authorized service or your distributor:

Moisture got into the phone.

The phone is mechanically damaged.

The phone is extremely overheated.

The given symbol (crossed-out wheeled bin) on the IGET T1 product or at accompanying documents means that used electrical and electronic products should not be disposed of with household waste. To ensure proper disposal of the product, hand it over to a designated collection point, where it will be accepted free of charge. The correct disposal of this product will help to save valuable natural resources and prevent any potential negative impacts on the environment and human health, which could otherwise be caused by inappropriate disposal of wastes. The improper disposal of this waste can be penalized in accordance with national regulations.

Italy – The conditions for using the WiFi network are described in the so-called Electronic Communications Code.

Norway – The 2.4 GHz limitation applies only to the area 20 km from colony of Ny-Ålesund.

When using a radio device in the 5150 – 5350 MHz frequency range, use is limited to indoor spaces only.

Max. 2 W

GSM: 850/900/1800/1900 MHz

WCDMA: 850/900/2100 MHz

LTE: 2100/1800/850/2600/900/800/700/2600/2300/2500 MHz

2.4G WiFi (20 MHz): 2412 – 2472 MHz

2.4G WiFi (40 MHz): 2422 – 2462 MHz

5G WiFi: (H20) 5180 – 5240 MHz

5G WiFi: (H40) 5190 – 5230 MHz

5G WiFi: (H80) 5210 MHz

The IGET T1 can be used in the following countries: