HERMITLUX HMX-DW03 (01) PDF DOCUMENT

When using your dishwasher, follow basic precautions, including the following:

a) Read all instructions before using the dishwasher.

b) Use the dishwasher only for its intended function.

c) Use only detergents or wetting agents recommended for use in a dishwasher and keep them out of the reach of children.

d) When loading items to be washed:

1) Locate sharp items so that they are not likely to damage the door seal;

2) Load sharp knives with the handles up to reduce the risk of cut-type injuries.

e) Do not wash plastic items unless they are marked “dishwasher safe” or the equivalent. For plastic items not so marked, check the manufacturer’s recommendations.

f) Do not touch the heating element during or immediately after use.

g) Do not tamper with controls.

h) Do not abuse, sit on, or stand on the door or dish rack of the dishwasher.

i) To reduce the risk of injury, do not allow children to play in or on a dishwasher.

j) Under certain conditions, hydrogen gas may be produced in a hot-water system that has not been used for two weeks or more. HYDROGEN GAS IS EXPLOSIVE. If the hot-water system has not been used for such a period, before using the dishwasher turn on all hot-water faucets and let the water flow from each for several minutes. This will release any accumulated hydrogen gas. As the gas is flammable, do not smoke or use an open flame during this time.

k) Remove the door to the washing compartment when removing an old dishwasher from service or discarding it.

l) DO NOT IMMERSE IN WATER.

m) HOUSEHOLD AND INDOOR USE ONLY.

n) It is forbidden to open the door while the appliance is working to avoid personal danger. Don’t open the door when washing avoiding to hot water flying out and causing any hurts.

1. Power socket must be grounded, avoiding possible electric leakage or shock;

2. Don’t share one socket with other appliances avoiding to fire;

3. Any new parts or power line will be changed by the service man after damages;

4. Dispose of the machine in an environmentally friendly manner under local regulations;

5. Do not place the machine in the environment under 32°F, like outside the door in cold weather;

6. Please use salt and detergent which is special for the dishwasher;

7. Don’t place and use the machine on the platform which is not stable, wet, smooth, inflammable avoiding any damage;

8. Don’t place and use the machine within 5.9″ far from the gas stove or heater;

9. Don’t place any heavy objects on the door when the door opening to avoid the machine turn over;

10. Don’t splash water into the machine avoiding electric shock or fire;

11. Don’t drink the left water in the machine;

12. Don’t let children operate the machine independently avoiding any dangerousness.

1. Don’t open the door when washing avoiding to hot water flying out and causing any hurts;

2. Don’t touch the block of the side air outlet;

3. Don’t tilt or move the machine when washing;

4. The knife or others with sharp points don’t face person to avoid any hurts when opening the door;

5. Please stop washing, power off, and close the tap when any faults;

6. Please check and clean the machine from time to time for the best washing effect;

7. Please fix the drain hose avoiding to the stained water outflow;

8. Don’t forcibly pull power cord, drain hose, or press cutlery tray avoiding any damage;

9. Don’t use a wet hand to operate the machine avoiding electric shock;

10. Children should be far from the chemical material such as salt, detergent avoiding to any hurt.

The main components of the machine are:

Water inlet

Top lid

Control panel

Spray arm

Filter

Door handle

Storage rack

Cutlery basket

Tableware basket

The parts list includes:

Inlet hose x1

Drain hose x1

Fruit basket x1

1.8L water pitcher x1

Hose collar x1

1. Dry: Adds 73 hours’ circular wind to keep air fresh inside machine.

2. Tank model indicator

3. Tap model indicator

4. Display screen

5. Time display

6. Dry indicator

7. Temperature indicator

8. Door open indicator

9. Standard program indicator

10. Quick program indicator

11. ECO program indicator

12. Strong program indicator

13. Fruit program indicator

14. Program selection button

15. Start/Pause button

16. Power on/off button

This appliance must be grounded. In the event of a malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance to electric current. This appliance is equipped with a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is installed and grounded in accordance with all local codes and ordinances.

WARNING: Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service representative if you are in doubt about whether the appliance is properly grounded. Do not modify the plug provided with the appliance, if it will not fit the outlet, have a proper outlet installed by a qualified electrician.

1. Connect to the machine: Insert the inlet hose elbow into the water inlet behind the machine and tighten the screw.

2. Connect to the tap: There are three options (A, B, C as shown in the manual diagram) for tap connection. Options B and C require making a hole on or behind the cabinet for the hose to pass through.

Note:

The product has the characteristic of heating liquid.

Water temperature should not be over 104°F if using hot water.

The size of the inlet hose elbow is 1/2″ with internal thread; the tap size must be 1/2″ with outer thread.

1. Connect to the machine: Insert the drain hose elbow into the water outlet behind the machine and tighten the collar.

2. Connect to the sewer: There are three options (A, B, C as shown in the manual diagram) for sewer connection. Options B and C require making a hole on or under the cabinet for the pipe to pass through.

Note: A hose that attaches to a sink spray can burst if it is installed on the same water line as the dishwasher. If your sink has one, it is recommended that the hose be disconnected and the hole plugged.

1. Please get rid of large food residue on tableware to avoid blocking the water hose.

2. Please make reference to the picture in the manual for tableware display.

Note: In order to fully clean tableware, please tilt tableware internally or put stained face down. The capacity of the maximum number of place settings is six.

1. Power on: Plug in, touch the Power on/off button to turn on the machine. To force the machine to turn off before a program finishes, hold the Power on/off button for 3 seconds.

2. Add detergent: Open the door, add moderate detergent powder, or 1pc detergent block into the machine, and close the door. The recommended dosage is 8-10g for each washing cycle. No detergent is needed for fruit washing.

3. Program selection: Touch the Program selection button. Each of the program indicators will light one by one. Select the program you want.

4. Run program: Touch the Start/Pause button to run the selected program. The machine will check the water supply automatically.

The machine has two water supply models: tap model and tank model.

The indicator for the tank model is a faucet icon with a water drop. When white, it means tank model is active.

The indicator for the tap model is a faucet icon. When white, it means tap model is active.

If the tank is full, the machine will switch into tank model automatically.

For tank model, fill 3 cups (using the 1.8L water pitcher) of water into the tank. A “Di, Di, Di” sound will be heard if the tank is full, and the tank model indicator will become white.

For tap model, please open the water tap.

1. Disassemble: Rotate anti-clockwise to disassemble the filter set, which has 3 parts: filter mesh, main filter, and fine filter.

2. Clean: Use water to flush and brush each of the filter parts.

3. Assemble: After cleaning, rotate clockwise to close the filter set.

1. Disassemble: Open the door, take out the basket, then pull out the up and down spray arms.

2. Clean: Use water to flush and brush each spray arm. Use tools with sharp points, like a needle, to clean holes if needed.

3. Assemble: After cleaning, please press each arm into position, make sure the arm can move smoothly.

If the machine is currently washing, you cannot select a new program. Re-select the program after stopping the in-progress program or wait for the in-progress program to finish.

This may be due to an overly high washing temperature. Select the program with a lower temperature.

This is caused by using incorrect detergent. Follow these steps:

1. Use special detergent for the dishwasher.

2. Open the machine, and wipe out the foam by hand.

3. Fill 2-3L of water into the machine, and select any program. After 1-2min, the foam will be drained. Repeat the process if needed.

This is due to protein solidification. Clean the tableware with egg custard by hand.

This means the drying time is not enough. Select the “Dry” program.

The table is made according to SJ/T11364 standards.

O: indicates the hazardous substance contain is below the limit of GB/T26572 standards.

X: indicate the hazardous substance contain is over the limitation of GB/T26572 standards, but fit for the RoHS order.