HEARTH HOME TECHNOLOGIES DM1736 (01) PDF MANUAL

HEARTH & HOME TECHNOLOGIES DM1736 (01) PDF SUMMARY:

How do I install the bi-fold glass doors?

Fold one pair of doors. Insert the pin into the large hole located at the bottom outside corner of the fireplace opening. Tilt it toward the center of the fireplace such that the pins clear the top door track edge. Slide the pin into the top door track until the pin snaps into the hole in the spring clip.

How do I adjust the doors?

Doors may be adjusted by repositioning the spring clips in the screw slots, by loosening the screws and then retightening. Do not overtighten the screws!

How do I remove the doors if necessary?

Depress the spring clips located in the upper corners of the fireplace and tilt the doors towards the center of the fireplace opening.

What precautions should I take during installation?

Wear protective gloves and safety glasses during installation.

What should I do before burning the fireplace for the first time?

Wipe the trim with a clean, dry rag to remove all smudges and fingerprints. Failure to do so will cause smudges and fingerprints to be burned into the finish of the trim.

What precautions should I take when burning the fireplace?

Close firescreen when burning fireplace. Do not use firescreen or glass doors to hold burning material in the fireplace. Firescreen controls sparks. Glass may break or burning material may roll out. Doors must be fully opened or fully closed when operating fireplace. Partially opened doors may draw flame, smoke or heat from the fireplace.

How should the doors be positioned when operating the fireplace?

The doors must be fully opened or fully closed.

Why should the doors be fully opened or fully closed when operating the fireplace?

Partially opened doors may draw flame, smoke, or heat from the fireplace.

What is the benefit of using glass doors?

Glass doors aid in the prevention of loss of room heat through an open chimney.

What is required for door installation on the RBV4236 or RBV4842?

Door installation on the RBV4236 or RBV4842 requires longer pins. The longer pins and screws to attach them are located on the valve bracket of the appliance.

How do I install the longer pins on the RBV4236 or RBV4842?

Remove the shorter door pins using a phillips screwdriver and replace them with the longer pins.

What should I do before placing the door tracks on the Odvilla-36, Odvilla-42 Outdoor Woodburning Fireplace?

Remove the screws from the door track area before placing the door tracks on the fireplace. Once in place reinsert screws.