FREE ENGLISH HART HW142500 (01) PDF USER GUIDE
FREE ENGLISH HART HW142500 (01) PDF USER MANUAL
FREE ENGLISH HART HW142500 (01) PDF OWNER GUIDE
FREE ENGLISH HART HW142500 (01) PDF OWNER MANUAL
FREE ENGLISH HART HW142500 (01) PDF REFERENCE GUIDE
FREE ENGLISH HART HW142500 (01) PDF INSTRUCTION GUIDE
FREE ENGLISH HART HW142500 (01) PDF REFERENCE MANUAL
FREE ENGLISH HART HW142500 (01) PDF INSTRUCTION MANUAL
FREE ENGLISH HART HW142500 (01) PDF OPERATING INSTRUCTIONS
CLICK HERE TO DOWNLOAD HART HW142500 (01) PDF MANUAL
If this is not the document you want for this product, click here to see if we have any other documents for this product.
What is the main warning for this product?
This quick reference guide is not a substitute for reading the operator’s manual. To reduce the risk of injury or death, user must read and understand operator’s manual before using this product.
How do I assemble the pressure washer for the first time?
1. Install the wheels.
2. Install the handle and nozzle storage bracket.
3. Connect the spray wand to the trigger handle.
4. Connect the high pressure hose to the trigger handle.
5. Connect the high pressure hose to the pump.
6. Connect your garden hose to the pressure washer.
After connecting the garden hose, follow these steps:
• Completely uncoil garden hose or remove completely from reel to prevent kinks.
• Turn water faucet on fully.
• Make sure there are no leaks.
• With no nozzle installed, squeeze the trigger to relieve air pressure. Hold the trigger until a steady stream of water appears.
How do I start and stop the unit?
1. Connect the pressure washer to the power supply. Press the reset button on the plug to make sure the unit is ready for operation.
2. Put the on/off switch in the ON position to start the motor.
3. When finished, put the on/off switch in the OFF position.
Can I use an extension cord with this pressure washer?
This pressure washer is not recommended for use with an extension cord. If using an extension cord, arrange a drip loop to avoid the possibility of the tool plug getting wet.
Use only the following size extension cord when using this product:
| Cord Length | Wire Size (A.W.G.) |
|---|---|
| 25 ft. | 12 |
| 50 ft. | Not Allowed |
NOTE: A.W.G. = American Wire Gauge
Why is there water in the pump of my new pressure washer?
There may be residual water in the pump due to performance testing.
How do I use detergent with the pressure washer?
1. Pour pressure washer detergent in the soap tank.
2. Install the blue or black soap nozzle.
3. Squeeze the trigger and wait approximately 5 seconds for detergent to appear.
Use of the soap nozzle will activate the soap injector at a 20:1 dilution ratio.
WARNING! Never use bleach or solvent-based detergent.
• It will damage your pump.
• It will void your warranty.
• It will damage plants/shrubs.
Which nozzle should I use for my job?
Use the chart below to determine the correct nozzle for your job.
| HIGH PRESSURE (NO SOAP WHEN USING THESE NOZZLES) |
LOW PRESSURE (FOR SOAP OR GENTLE RINSE) Blue Soap Nozzle |
||
|---|---|---|---|
| Turbo Nozzle | 15° | ||
| Concrete, Brick, Masonry | ✔ | ✔ | ✔ |
| Siding, Gutters, House | ✔ | ✔ | |
| Fencing, Deck, Patio | ✔ | ✔ | |
| Lawn Equipment, Boat, RV | ✔ | ✔ | |
✔ Recommended Nozzle
✔ Use With Caution for Certain Applications (Fencing, Deck, Patio and Lawn Equipment, Boat, RV with the 15° nozzle).
What should I do before storing the unit?
Always add Pump Protector to the unit after each use and before storing. This will significantly improve pump life.
Pump protector is available from your local retailer. To add, follow the instructions provided by the Pump Protector manufacturer.
CLICK HERE TO DOWNLOAD HART HW142500 (01) PDF MANUAL