GRI 2826FS (01) PDF MANUAL

GRI 2826FS (01) PDF SUMMARY:

How do I install the GRI 2826 detector?

Place the unit where liquid is most likely to accumulate. Clean and dry the desired placement location, a smooth surface is preferable and preparing the surface by using an alcohol wipe is recommended. Remove the protective paper from the double-sided tape, then stick the unit to the cleaned surface.

How do I connect the 2826 detector wires to an external device?

See the installation instructions for that device. Use the white and red wires for a closed loop circuit, or the white and black wires for an open loop circuit.

What should I do after installing the GRI 2826 detector?

Test the unit with water and inspect annually. If there is any corrosion or damage, the sensor should be replaced.

How do I mount the 2826FS detector relay?

Mount the 2826FS detector relay on a wall no more than 100 feet from the desired location to be monitored.

Where do I mount the sensor probes for the 2826FS?

Mount the sensor probes at locations where liquid pooling is most likely to occur.

How should I wire the sensor probes for the 2826FS?

Run probe wires from sensor probes to the detector relay and connect wires to sensor terminals. Wire all sensor probes in parallel.

How do I connect to external devices using the 2826FS?

Use the relay contact terminals to connect to external devices such as wireless transmitters or connect directly to alarm or controller systems.

What should I do after installing the 2826FS detector?

These units should be tested with a damp sponge or paper towel and inspected annually. If there is any corrosion or damage the sensor should be replaced.