GE ZKGT304NRH (01) PDF MANUAL

Read these instructions completely and carefully.

WARNING: This Refrigerator is top heavy and must be handled with care.

Failure to do so can result in the unit tipping over and result in death or serious injury.

Before beginning installation, ensure that the anti-tip bracket is correctly installed.

These kits are to be used with the following models:

ZKGP300N

ZKGP304NLH

ZKGP304NRH

ZKGT300N

ZKGT304NLH

ZKGT304NRH

ZKSP300N

ZKSP304NLH

ZKSP304NRH

ZKST300N

ZKST304NLH

ZKST304NRH

The following hardware and brackets are shipped with the refrigerator, located in the bottom drawer:

Description	Qty
washer	2
nut	2
hinge pin	2
screw A	16
screw B	45
hook	8
lower bracket	3
Top bracket	1

Use the lowest set of holes on the door and align the hook towards the outside edge of the door.

The lower brackets on the Fresh Food & Convertible Drawer should not be installed until after the panel is in place.

ATTENTION: Remove protective film from stainless steel panels after they are mounted and in final position on the doors. Removing film earlier can expose the panels to damage during installation.

1. Use Screw B to attach hooks and brackets to panels. Use Screw A to attach brackets to doors and drawers of the refrigerator.

2. Remove all door and drawer hooks from the unit and screw them to the custom panels, aligning them with the lowest set of pre-drilled holes for Monogram Panel Kits on the FF (Fresh Food) door panel.

3. Attach the top-Bracket to the FF panel.

4. If you had custom handles made and they are not currently attached to your panels, do so now.

5. Open the fresh food door to attach the fresh food panel.

6. Slide the hooks on the fresh food panel into the slots of the door, and lower the hooks into place. Make sure the bracket on the top of the panel slides over the screw posts on top of the door. (Note: Hooks on the Freezer drawer panel face up).

7. Adjust the screw posts up or down under the bracket on top of the door to level the panel.

8. Lock the panel to the door by installing the nuts provided onto the screw posts on top of the door. Next, screw the lower-bracket provided into the bottom of the door (using screw A) and the panel (using screw B).

9. Install the Freezer drawer panel by sliding the brackets up into place (this is the opposite direction of the hooks on the fresh food panel and Convertible drawer).

10. Once the Freezer drawer panel is placed, fasten the panel to the drawer by screwing the bottom bracket into the panel with the screws (B) and into the drawer with screws (A).

11. Repeat for the second drawer (Convertible drawer) by sliding the hooks down instead of up.

12. Adjust drawer alignment using lower brackets as needed to create uniform gaps.

13. If using a custom toekick, attach the toekick panel by placing velcro on the back of the panel and on the front of the unit. If using a stainless steel toekick, it’s magnetic.