GAMERTECH AM4215 (01) PDF DOCUMENT

Please ensure that you have read the product manual and instructions in full before using this product. Failure to do so may result in incorrect operation and potentially impact the performance of the product.

WARNING: The manufacturer is not responsible for any potential injury from misuse.

Prior to using your GAMERTECH AM4215, please read all the safety and operating instructions thoroughly. Please ensure you follow the steps below before using the product. We recommend you keep the original packaging for storing the product when not in use.

Please pay close attention to the section entitled Warnings & Safety Information. Find a safe and convenient place to keep this instruction manual for future reference.

Unpack the product but keep all packaging materials until you have made sure your new product is undamaged and in good working order. Ensure you have all accessories listed in this manual.

1x Microphone

1x USB-C to USB-A Cable

1x Mount Adapter

1x User Manual

1. Condenser Mic

2. Anti-shock Mount

3. Volume Knob

4. Stand Base

5. Polar Pattern Knob

6. Type-C Port

7. Earphone Port

8. LED Indicator Ring

9. Noise Suppressor

10. Mute Button

11. LED Lighting Button

12. 3/8”, 5/8” Adapter

You can adjust the angle of the microphone as required while it is on its stand base. The microphone can also be mounted to a boom arm with the mount adapter supplied. (Note: Boom arm not included).

1. Plug the microphone into the USB socket of a PC or Laptop.

2. Wait about one minute, the microphone will install automatically.

3. Check the device manager of your computer, to make sure this microphone is recognised by the computer.

4. Set this product to current default in the recording & playback device settings.

Cardioid Mode: Suitable for individual calls, gaming, streaming, voice over, podcasting, ASMR, vlogging etc.

Omni Mode: Suitable for business calls, group streaming, group voice over, multi-person podcasting, group music recording etc.

Turn the volume knob to adjust the volume of recording as required.

Touch the mute key quickly to mute. The LED indicator ring will change to red and other light will be turned off at the same time.

Touch the key one time, and low environmental noise will be cancelled. The LED indicator ring will blink. Touch the key again to disable noise suppression.

Touch the key to loop switch between different lighting modes.

Ensure this product is selected in the playback device settings of your computer. Plug in a headphone with a 3.5mm port (headphone not included) into the earphone port. Adjust the volume through the computer.

Mic Type	Condenser x2
Sampling Rate	192kHz/24bit
Sensitivity	-38+/-3dB
S/N Ratio	>85dB
Polar Patterns	Cardioid/Omni
Working Voltage	5V
Working Current	150mA
Frequency Response:	20H2-20KHZ
Distortion	<2%
System Support	Windows/MacOS/Android/iOS