EAZYZAP Y725 (01) PDF MANUAL

A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components or service panels on this product.

Consult Local and National Standards to comply with the following:

• Health and Safety at Work Legislation

• BS EN Codes of Practice

• Fire Precautions

• IEE Wiring Regulations

• Building Regulations

Always switch off and disconnect the power supply to the appliance before cleaning.

Install the appliance out of the reach of children.

Never insert hands or other objects into the appliance while it is connected to the power supply.

Install the Fly Killer at least 1 metre away from food preparation areas.

Never use near flammable objects.

For INDOOR use only.

Keep all packaging away from children.

If the power cord is damaged, it must be replaced by an EAZYZAP agent or a recommended qualified technician in order to avoid a hazard.

The following is included:

• Fly Killer

• Instruction manual

• Hanging chain

Note: Ensure the mounting substrate and the fixings used can support the weight of the appliance. If in doubt seek professional advice or assistance.

1. Remove all packaging and protective film from the Fly Killer.

2. For best results, locate the Fly Killer in the darkest part of the room, but at least 1 metre away from food preparation areas.

Note: Close proximity to other light sources such as sky lights and windows will reduce the effectiveness of the Fly Killer.

3. Connect the appliance to mains power.

WARNING: Under no circumstances should hands be placed anywhere near the high voltage grid when the appliance is operational.

The fly killer works by luring insects on to an electrified metal grid using ultra-violet light. It uses no chemicals and is pollution free. To use the Fly Killer:

1. Press the switch to the ON position.

2. The light will come on and the grid will become electrically charged.

• Always switch off the power and disconnect the appliance from the power supply before cleaning.

• Clean the collection tray regularly with warm soapy water.

• DO NOT immerse the appliance in water. Wipe the safety guard and external casing with a damp cloth.

• Change the bulbs every 9 months.

WARNING: Always turn Off the appliance and disconnect from the power supply before changing the bulb.

1. Remove the catch tray.

2. Lay the appliance face down.

3. Unscrew the two screws holding the safety guard at the rear of the Fly Killer.

4. Lift up the guard rail.

5. Holding the ends of the bulb, twist it ‘forwards’ in its socket until it clicks.

6. Slide the bulb up out of its sockets.

7. Replace with a new bulb.

8. Twist the new bulb ‘backwards’ to lock it back in place.

9. Replace the guard rail and the two screws.

If your appliance develops a fault, please check the following table.

This appliance is supplied with a 3 pin, moulded, BS1363 plug and lead, with a 3 amp fuse as standard. The plug is to be connected to a suitable mains socket.

This appliance is wired as follows:

• Live wire (coloured brown) to terminal marked L

• Neutral wire (coloured blue) to terminal marked N

• Earth wire (coloured green/yellow) to terminal marked E

This appliance must be earthed, using a dedicated earthing circuit.

If in doubt consult a qualified electrician.

Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required they must be readily accessible.