DYNOJET DYNOWARE RT (01) PDF MANUAL

The DynoWare RT OBD2 Data-Link Interface plugs directly into the CAN-based vehicle’s OBD2 port and brings data from the vehicle’s ECM directly into DynoWare RT. The OBD2 engine RPM channel can be used as your dyno’s primary RPM signal. Data can be viewed in real-time and saved with the dyno graph.

1. Verify the vehicle is grounded to the dyno. Note: To avoid damage to the OBD2 Data-Link and your vehicle, the vehicle must be grounded to the dyno.

2. Locate the OBD2 port on the vehicle.

3. Connect the Data-Link to the OBD2 port on the vehicle.

4. Connect the OBD2 cable to the Data-Link.

5. Connect the OBD2 cable to the powersports port on the DynoWare RT main module.

1. Start the vehicle.

2. Start Power Core software.

3. Click WinPEP 8 Dyno Control from the Application Launcher.

4. Connect to the DynoWare RT.

5. Click the Configuration tab.

6. Click RPM Configuration.

7. Select OBD2 from the RPM Source drop-down list.

8. Click OK.

All vehicles model year 2008 and newer manufactured or imported to North America.

Most post 2003 vehicles that have the OBD2 pins populated for CAN.