DOMETIC AIR BREAK PRO 1 DOOR (01) PDF MANUAL

DOMETIC AIR BREAK PRO 1 DOOR (01) PDF SUMMARY:

What should I read carefully to properly install, use, and maintain the product?

Read all instructions, guidelines, and warnings included in the product manual to ensure proper installation, use, and maintenance of the product. These instructions must stay with the product. By using the product, you confirm that you have read and agree to abide by the terms and conditions set forth in the product manual. Use the product only for its intended purpose and application, following all instructions, guidelines, and warnings. Failure to read and follow instructions and warnings may result in injury, product damage, or damage to other property. The product manual, including instructions, guidelines, warnings, and related documentation, may be subject to changes and updates; visit dometic.com for up-to-date information.

---

What could happen if I fail to follow the instructions and warnings?

Failure to read and follow the instructions and warnings set forth herein may result in an injury to yourself and others, damage to your product or damage to other property in the vicinity.

---

Where can I find up-to-date product information?

For up-to-date product information, please visit dometic.com.

---

What do the symbols in the manual mean?

• WARNING! Indicates a hazardous situation that, if not avoided, could result in death or serious injury.
• CAUTION! Indicates a hazardous situation that, if not avoided, could result in minor or moderate injury.
• NOTICE! Indicates a situation that, if not avoided, can result in property damage.
• NOTE Supplementary information for operating the product.

---

What are the general safety instructions?

• Make sure you know the fire precaution arrangements on the site.
• Do not cook inside or near the windbreak or use open flames.
• Do not allow children to play around the windbreak and ensure that suitable protective footwear is worn. Guy lines are a trip hazard and pegs can be sharp.
• Cleaning and user maintenance may not be carried out by unsupervised children.
• Keep passage ways clear.

---

What is included in the scope of delivery?

• Windbreak
• Peg pack
• Carry bag

---

What is the windbreak suitable for?

The windbreak is suitable for:

• Connecting to an awning tent
• Freestanding (AIR Break Pro 1/3/5 and AIR Break All-Season 1/3/5 only)
• Light to moderate weather
• Touring

---

What is the windbreak not suitable for?

The windbreak is not suitable for:

• Very strong winds or snowfall
• Seasonal pitch* or commercial use * All-Season models have been designed for use on seasonal pitches

---

What could result in unsatisfactory performance and possible failure of the windbreak?

Poor installation and/or improper operating or maintenance will result in unsatisfactory performance and a possible failure.

---

What is the manufacturer not liable for?

The manufacturer accepts no liability for any injury or damage to the product resulting from:

• Incorrect assembly or connection, including excess voltage
• Incorrect maintenance or use of spare parts other than original spare parts provided by the manufacturer
• Alterations to the product without express permission from the manufacturer
• Use for purposes other than those described in this manual

---

What should I do before using the windbreak for the first time?

Before first use, familiarize yourself with the product by carrying out a test set up before the product is used for the first time. Check if the scope of delivery is complete.

---

How do I choose a site for the windbreak?

1. Choose a flat site.
2. Choose a shaded site to avoid UV degradation of the fabric.
3. Avoid pitching under trees as falling branches, resin, etc. can damage the product.
4. Clear the site of sharp stones and debris.
5. If used freestanding, set up the windbreak with the opening facing away from the wind.

---

What should I never do while an air pole is inflated?

Never open the zipper on the protective sleeve while an air pole is inflated. This will result in the air pole bursting.

---

What type of compressor should I avoid using?

Do not use any type of compressor designed to inflate car tires.

---

How much should I inflate the air poles?

Only inflate the air poles into the green zone of the pressure gauge of the hand pump supplied with the main awning tent (9 psi/0.62 bar).

---

What should I avoid doing with zippers?

Do not open or close the zippers by force.

---

What should I do if the supplied pegs are not suitable for the ground?

The supplied pegs will be suitable for many sites but for some types of ground special pegs will be needed. Ask your dealer.

---

At what angle should I drive the pegs into the ground?

Drive the pegs at a 45° angle away from the windbreak into the ground.

---

How should I peg each guy line?

Peg each guy line in-line with the seam they start from.

---

What tips should I keep in mind while setting up the windbreak?

• The illustrations provide a general overview of the set up. The actual set up will vary slightly based on the model of windbreak.
• Get help. The set up is easier with more people.
• Peg the guy lines so that the windbreak is under tension without distorting the shape.
• Check the guy lines from time to time to ensure adequate tension, if necessary use the runners to adjust.

---

How do I set up the windbreak?

1. To protect the windbreak from dirt and damage, lay down a groundsheet or footprint before unpacking.

2. Unpack the windbreak.

3. Separate and identify the different components.

4. Proceed as follows depending on the type of set up:

   • To connect the windbreak to an awning tent, set up the windbreak as shown (fig. 2, page 3 to fig. 6, page 5).
   • To use the windbreak freestanding (AIR Break Pro 1/3/5 and AIR Break All-Season 1/3/5 only), set up the windbreak as shown (fig. 3, page 4 to fig. 6, page 5).

---

How do I extend the windbreak?

• To connect the windbreaks use the zippers on the sides (fig. 8, page 5).
• To set up the AIR Break Pro Door/ AIR Break All-Season Door proceed as shown (fig. 9, page 6 to fig. c, page 7).

---

How do I dismantle the windbreak?

1. Remove all dirt from the windbreak.

2. Unpeg all pegging points and unclip all guy lines.

3. Deflate the windbreak:

   • AIR Break Pro 3/5 and AIR Break All-Season 3/5: Open the deflation valves (fig. 7, page 5).
   • AIR Break Pro 1/ Door and AIR Break All-Season 1/ Door: Open the inflation valves.

4. Fold/roll the windbreak towards the valves to expel more air.

5. When deflated, roll the windbreak to fit into the carry bag.

6. Zip and tighten the compression straps.

7. Ensure that all parts are clean before packing them into the carry bag.

8. If the windbreak is wet or damp, dry fully as soon as possible.

---

How should I store the windbreak?

1. Clean the windbreak.
2. Air fully and ensure the windbreak is totally dry before packing away.
3. Store in a well ventilated dry place.

---

How do I clean and maintain the windbreak?

1. If necessary, clean the product with clean water and a soft brush.
2. Apply impregnation against water and UV radiation before each trip.

---

What should I keep in mind while cleaning the windbreak?

• Fully set up the windbreak for cleaning.
• Choose a sunny day for cleaning to ensure the material will dry thoroughly.

---

What should I avoid when cleaning the windbreak?

• Do not use sharp or hard objects or cleaning agents for cleaning.
• Do not use alcohol based materials, chemicals, soap and detergents for cleaning.
• Remove bird droppings and tree resin as soon as possible to avoid permanent damage to the material.

---

How should I dispose of the windbreak?

• Place the packaging material in the appropriate recycling waste bins, wherever possible.
• Consult a local recycling center or specialist dealer for details about how to dispose of the product in accordance with the applicable disposal regulations.

---

What does the warranty cover?

The warranty covers manufacturing defects, materials and parts.

---

What does the warranty not cover?

The warranty does not cover fading of the cover and wear and tear due to UV radiation, misuse, accidental damage, storm damage, or permanent, semi-permanent* or commercial use. It does not cover any resulting damage.

---

What should a fully equipped spare parts kit include?

• Waterproofer
• Repair tape and repair solution
• Silicone spray for the zippers
• Spare pegs

---

What should I do if the windbreak only inflates with difficulties?

• Check that the valve is fully screwed into the air pole.
• Check if the inflation tube is twisted at the valve. This may be indicated by noise. Untwist the inflation tube.
• Check that the hand pump is working.

---

What should I do if the air poles are kinked?

Add more air (9 psi/0.62 bar).

---

What should I do if there is an air leak?

• Check that the valve is fully screwed into the air pole and the ring seal is in place.
• Check that the cap of the valve is done up tightly.

---

What should I do if there is a rip in the fabric?

• Use repair tape to seal the fabric.
• Have repairs carried out by an authorized service agent.