Post questions, comments, reviews or page errors in the comment box below.
PDF Content Summary:
****** Page 1 ****** INSTRUCTION MANUAL Air Circulator Model: DCACM20 For domestic household use only.
****** Page 2 ****** IMPORTANT THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE. Note also the information presented on the appliance CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE INJURY AND/ OR DAMAGE AND MAY INVALIDATE YOUR WARRANTY Please read the operating instructions carefully before using your air circulator for the first time and keep them in a safe place. WARNING – This appliance must not be used in a bathroom. Do not use this appliance in the immediate surroundings of a bath, a WARNING shower or a swimming pool. Never immerse the appliance in water or other liquids. Do not place on soft, unstable or non-horizontal/angled surfaces. Never operate the appliance if a cable or connector has been damaged, after appliance malfunction or if the appliance was dropped or is otherwise damaged. If the mains lead is damaged it must only be replaced by the manufacturers service agent or a similarly qualified person in order to avoid a hazard. Please ask a professional service agent to repair the product. Improper repair may cause danger to users. Disconnect the appliance from mains power whenever it is not in use, before relocating it, and before cleaning. Operate the appliance only at the voltage specified on the rating label. Only connect the unit to a properly installed and easily accessible socket so that you can quickly disconnect the plug if necessary. Do not connect this product to the mains using an extension lead. This air circulator is only intended for INDOOR RESIDENTIAL applications. This air circulator should not be used for commercial or industrial or leisure applications or in small enclosed spaces. Never use the mains lead as a carrying strap or pulling lead. To avoid a fire or electrocution hazard, NEVER put the cord near heat registers, radiator, stoves or heaters. DO NOT cover cord with carpeting, throw rugs, runners, or similar coverings. DO NOT route cord under furniture or appliances. Take care to position the cord away from traffic areas and where it will not be a tripping hazard. DO NOT use the unit near windows or where water collects. Rain and water collection may lead to a risk of fire or electric shock. DO NOT COVER. Only operate this appliance with a minimum of 50cm clearance all around i.e. away from walls, furniture and overhanging objects such as curtains or a shelf. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. 2
****** Page 3 ****** Children should be supervised to ensure they do not play with the appliance. To avoid danger of suffocation please remove all packaging materials WARNING particularly plastic and EPS and keep these away from vulnerable people, children and babies. NEVER drop or insert any object or fingers into any openings. Do not use the appliance in locations where paint, petrol or other flammable liquids are used or stored. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. Do not use bug sprays or other flammable cleansers/vapour sprays on or around the unit. Always switch off the unit and take the plug out of the socket: • If you are not using the unit • Before you clean or carry out maintenance on the unit • If a fault occurs • In the event of an electrical storm. Avoid electromagnetic interference. Keep the unit at least 1 metre away from electrical appliances such as televisions & radios. 3
****** Page 4 ****** Exposed to the weather outdoors Where small children may be left unattended On a slope or uneven surface Where there is a risk of interference by foreign objects 4 Near water If an extension lead may become overloaded Where there is risk of fire or close to a naked flame This product is not made for DIY repair If the power cable wires are frayed or cut cable may be damaged Where it may be damaged by chemicals If there is a risk of water falling on the unit
****** Page 5 ****** Specification Model no. Power supply Rated power Speed settings Modes Timer Air movement Wind speed Vertical oscillation Horizontal oscillation Noise level Weight (net) Dimensions (w xd x h) DCACM20 220-240V-, 50Hz 2 20m 7m/s 90 degrees 360 degrees 35dB(A) [low speed] 1.9kg 225 x 215 x 320mm • For greater precision, please always refer to the rating label placed on the product. 5
****** Page 6 ****** How It Works In contrast to a traditional fan which brings only cooling benefits when directly facing you; an air circulator works for any season, keeping the air in motion and making the entire room more comfortable to be in. Most fans simply lack the aerodynamics to keep the air in the room in motion. As opposed to blowing air directly in contact with it, our Whirl Tech air circulators create a 3600 oscillating draught in the form of an invisible jet stream. This jet stream helps maintain a constant room temperature by ridding the room of cold and warm spots. It also clears stuffy atmospheres by circulating stale air with fresh air from an open window. Air circulators are the safe, all-year-round temperature regulation solution you’ve been looking for. Where To Position During Summer, pointing the air circulator towards a wall halfway between the floor and the ceiling, as well as using the highest setting, will set up a high speed air circulation pattern. This will cool down the room in an efficient manner. Pointing towards your air conditioner will help distribute the cool air faster, saving time and energy; essentially Turbo boosting your A/C. During Winter, the use of a heater alone produces warm air that rises naturally to the ceiling. By pointing the air circulator upwards, and utilising the lowest speed setting, the hot air will circulate with the cooler air near the floor, resulting in a more even room temperature. 6
****** Page 7 ****** Front grille Brand badge Setting Panel Rear housing Power cord Dial Base Pivot point horizontal oscillation 7
****** Page 8 ****** Control Panel Low speed & oscillation Settings OFF Off OFF High speed & oscillation Low speed High speed When the dial is aligned to the ‘OFF’ marker, the unit will be/ turn off. Turn the dial left or right of this marker, and the unit will turn on. LOW SPEED Turn the dial one click right from the OFF position to operate in Low Speed. LOW SPEED + OSCILLATION When operating in low speed, turn the dial right once more to start oscillation. From the OFF position, turn the dial two clicks to the right. HIGH SPEED Turn the dial one click left from the OFF position to operate in High Speed. HIGH SPEED + OSCILLATION When operating in High speed, turn the dial left once more to start oscillation. From the OFF position, turn the dial two clicks to the left. 900 VERTICAL TILT Tilt the fan head to achieve up to 900 angled oscillation. Ensure the fan is OFF when adjusting the fan head position. 8
****** Page 9 ****** Operation Steps 1. 2. 3. 4. Remove the unit from its packaging. Plug the unit into a power outlet. Turn the dial to the desired setting to turn the unit on. To switch the unit off at any time, turn the dial to the “Off” position. 9
****** Page 10 ****** Cleaning Over time, dust can accumulate on the grille covers and fan blades, which can affect the fans performance. It is recommended to clean the fan at least once a month. 1. 2. 3. 4. Turn the unit OFF and disconnect the appliance from the power supply. Remove any dust build up with a soft brush. To clean fan blades, remove the screw positioned on the back of the grille and turn the front grille counterclockwise (refer to diagrams below). Wipe the surface of the unit with a soft damp cloth. Mild detergent can be used for any stubborn marks. IMPORTANT The control panel and other parts must not come into contact with water or any other liquids. Storage If not using the unit for an extended period of time. After cleaning please: Turn the unit off, unplug and take care of the mains lead & plug. Cover the unit and store it upright in a location where it will not receive direct sunlight. NB- Prolonged exposure to direct sunlight will discolour the enclosure. 10
****** Page 11 ****** Maintenance If the unit fails to operate efficiently, is broken or other problems arise, unplug and do not operate. Ask for advice by calling your local after sales service agent or the Customer Care Centre on 1300 556 816 (AU) / 0800 666 2824 (NZ). Warranty Please refer to the warranty card in the box for warranty information. For any troubleshooting advice, please contact the relative Customer Care Centre below. Glen Dimplex Australia Pty Ltd 1340 Ferntree Gully Road, Scoresby 3179, Victoria Australia Ph: 1300 556 816 Glen Dimplex New Zealand Ltd 38 Harris Road, East Tamaki, Auckland 2013 New Zealand Ph: 0800 666 2824 Recyc//ng: Do not dispose of e/ectrica/ appliances as unsorted mun/c/pa/ waste. Use separate co//ection facilities. Contact your /oca/ government for Information regarding the co//ection systems avai/ab/e. /fe/ectrma/ apphances are disposed of /andfi//s or dumps, hazardous substances can leak into the ground watet; po//uting the food cha;n and damaging health and we//-being.
****** Page 12 ****** Customer Care: 1300 556 816 firstname.lastname@example.org XDimplex@ dimplex.com.au Supplied by Glen Dimplex Australia 1340 Ferntree Gully Road, Scoresby, Victoria, 3179 O Glen Dimplex Australia. A1 rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Glen Dimplex Australia 12
FREE ENGLISH PDF
USER GUIDE – USER MANUAL
OWNER GUIDE – OWNER MANUAL
REFERENCE GUIDE – REFERENCE MANUAL
INSTRUCTION GUIDE – INSTRUCTION MANUAL