DELL SE2219HX (01) PDF MANUAL

1. Align and insert the stand riser into the designated slot on the back of the monitor.

2. Secure the stand riser to the monitor by turning the captive screw clockwise until it is tight, as indicated by the arrow in the diagram.

3. Attach the stand base to the bottom of the stand riser by aligning and inserting it.

4. Secure the stand base to the riser by turning the thumbscrew on the bottom of the base clockwise until it is tight.

1. Ensure the stand is securely attached to the monitor while it is still in its protective packaging within the box.

2. Carefully lift the monitor, holding it by the stand or the protective packaging, upwards and out of the box.

Carefully peel off the protective film from the surface of the monitor screen. Start from a corner or edge as indicated by the diagram and pull gently.

1. Identify the video input ports on the back of your monitor. The diagram shows an HDMI port and a VGA port.

2. Connect one end of your video cable (e.g., HDMI or VGA cable) to the corresponding port on the monitor.

3. Connect the other end of the video cable to the video output port on your computer or other video source device.

1. Connect the female end of the AC power cord to the power input connector on the back of the monitor.

2. Plug the male end of the AC power cord into a standard electrical wall outlet.

1. Press the power button, typically located on the bottom edge or front of the monitor, to turn the monitor on.

2. Use the control buttons, usually located near the power button, to access and navigate the On-Screen Display (OSD) menu to adjust monitor settings.

To adjust the viewing angle, gently hold the monitor screen and tilt it forward up to 5 degrees or backward up to 21 degrees.