DELL P2317HWH (02) PDF MANUAL

1. Fit the two tabs on the upper part of the stand riser into the groove on the stand base.

2. Press down on the stand riser until it snaps into place.

3. Lift the screw handle on the bottom of the stand base and turn it clockwise to tighten the screw.

1. Place the monitor face down on a soft surface or within its protective packaging as shown.

2. Align the tabs on the assembled stand with the slots on the back of the monitor.

3. Slide the stand downwards until it locks firmly into place.

The monitor stand allows for:

Height Adjustment: Slide the monitor vertically up or down along the stand riser.

Swivel: Rotate the monitor horizontally left or right.

Tilt: Tilt the monitor forward up to 5° or backward up to 21°.

1. Connect the appropriate video cable (DisplayPort or VGA) from the corresponding port on the back of the monitor to your computer’s video output port.

2. To use the USB ports on the monitor, connect the square end of the USB upstream cable to the USB upstream port on the monitor, and connect the rectangular end to a USB port on your computer.

1. Connect the female end of the power cable securely into the power input port on the back of the monitor.

2. Plug the male end of the power cable into a working electrical wall outlet.

The power button and On-Screen Display (OSD) menu buttons are located on the bottom right edge of the monitor’s front bezel.

The CD includes drivers for the monitor and Dell Display Manager Software, along with product documentation.