DEEP SEA ELECTRONICS DSE2520 (01) PDF MANUAL


Post questions, comments, reviews or errors in the comment box below.

Your File is Ready … Download PDF

CLICK HERE TO DOWNLOAD DEEP SEA ELECTRONICS DSE2520 (01) PDF MANUAL


PDF Content Summary: The DSE2510 / DSE2520 Display Module is factory set to operate as DSENET® ID 0. If you use multiple display modules with the same host controller, you must select a unique ID for each display. This ID selection is performed in the ‘Running Editor’ of the Display Module. Customisation of the operation of the Display Module in the system is performed by configuring the host controller using it’s respective PC Configuration Software. ACCESSING THE ‘RUNNING’ CONFIGURATION EDITOR • The ‘running’ editor can be entered while the engine is running. All protections remain active if the engine is running while the running editor is entered. • Press and hold the button to enter the running editor. EDITING A PARAMETER • Enter the editor as described above. • Press the up or down buttons to select the parameter you wish to view/change. • To edit the parameter, press to enter edit mode. The parameter begins to flash to indicate that you are editing the value. • Press the up or down buttons to change the parameter to the required value. • Press to save the value. The parameter ceases flashing to indicate that it has been saved. • To exit the editor at any time, press and hold the button. ADJUSTABLE PARAMETERS Section Parameter as shown on display Factory Settings DISPLAY Contrast 53% Language English DSENet® ID 0

Deep Sea Electronics Plc. Tel:+44 (0)1723 890099 Fax: +44 (0)1723 893303 LO CALL (from UK BT landlines) Telephone 0845 260 8933 Email: support@deepseaplc.com Web: deepseaplc.com Deep Sea Electronics inc. Phone: +1 (815) 316-8706 Fax: +1 (815) 316- 8708 TOLL FREE (USA only) : Tel: 1 866 636 9703 Email: dsesales@deepseausa.com Web: deepseausa.com 053-064 ISS 1 Deep Sea Electronics Plc. (Far East) Tel:+66 2 670 6228 Fax: +66 2 678 3028 Deep Sea Electronics Plc. (Far East) Tel:+66 2 670 6228 Fax: +66 2 678 3028 Email: support@deepseaplc.com Web: deepseaplc.com Email: support@deepseaplc.com Web: deepseaplc.com

DEEP SEA ELECTRONICS DSE2510 / DSE2520 DISPLAY MODULE INSTALLATION INSTRUCTIONS TYPICAL WIRING DIAGRAM NOTE : A 120Ω termination resistor must be fitted to the last unit on the DSENet® data link cable. A termination resistor is internally fitted to the host controller which must be the ‘first’ unit on the DSENet® data link cable. TYPICAL ARRANGEMENT OF THE DSENET® WHEN CONNECTING MULTIPLE EXPANSION MODULES

DIMENSIONS 240.0mm x 181.1mm x 41.7mm (9.4” x 7.1” x 1.6”) PANEL CUTOUT: 220mm x 160mm (8.7” x 6.3”)


FREE ENGLISH PDF

OPERATING INSTRUCTIONS

USER GUIDE - USER MANUAL

OWNER GUIDE - OWNER MANUAL

REFERENCE GUIDE - REFERENCE MANUAL

INSTRUCTION GUIDE - INSTRUCTION MANUAL

Leave a Reply